GE 8102-HO-IP通道模拟输出模块
1.产 品 资 料 介 绍：
中文资料：
节点ID交换机在主机机箱中安装GE 8102-HO-IP之前，必须通过配置交换机S6来设置所需的节点ID。网络中的每个节点都必须有一个唯一的节点ID。有关交换机S6的位置，请参见第35页图2-1。开关S6是一个八位开关，对应于8条节点ID选择信号线。8个节点ID选择行允许从0到$FF（小数点后255）的任何节点ID。开关S6，位置1对应于最低有效节点ID线，位置8对应于最高有效节点ID线上。将开关位置设置为ON会将节点ID线设置为低（0），而将位置设置为OFF会将节点标识线设置为高（1）。
跳线E5用于为GE 8102-HO-IP配置冗余或非冗余传输模式以及roque master的选择。在引脚1和2上安装跳线分流器可选择非冗余（快速）传输模式。移除（省略）跳线分流器可将板配置为冗余网络传输模式。在引脚3和4上安装跳线分流器将禁用流氓主机0功能。从引脚3和4上卸下跳线可启用rogue master 0功能。在引脚5和6上安装跳线分流器将禁用流氓主机1功能。拆除引脚5和6上的跳线分流器可启用流氓主机1功能。请参阅下表2-2配置跳线E5
英文资料：
Node ID Switch Prior to installing the GE 8102-HO-IP in the host chassis, the desired node ID must be set by configuring Switch S6. Each node in network must have a unique node ID. See Figure 2-1 on page 35 for the location of Switch S6. Switch S6 is an eight position switch, which corresponds to 8 node ID select signal lines. The 8 node ID select lines permit any node ID from 0 to $FF (255 decimal). Switch S6, position 1 corresponds to the least significant node ID line and position 8 corresponds to the most significant node ID line. Setting the switch position to ON sets the node ID line low (0), while setting the position to OFF sets the node ID line high (1).
Jumper E5 is used to configure the GE 8102-HO-IP for redundant or non-redundant transfer modes as well as the selection of roque master. Installing a jumper shunt on pins 1 and 2 selects the non-redundant (fast) transfer mode. Removing (Omitting) the jumper shunts configures the board for the redundant network transfer mode. Installing a jumper shunt on pins 3 and 4 disables rogue master 0 function. Removing the jumper from pins 3 and 4 enables rogue master 0 function. Installing a jumper shunt on pins 5 and 6 disables the rogue master 1 function. Removal of the jumper shunt on pins 5 and 6 enables the rogue master 1 function. See Table 2-2 below to configure Jumper E5
2.产 品 展 示
3.主 营 品 牌
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
