RELIANCE 57401-2驱动数字I/O模块
1.产 品 详 情 资 料：
RELIANCE 57401-2嵌入式PROFINET控制器以下CPU支持一项功能，该功能允许将以太网LAN配置为用作PROFINET控制器：•RX3i CPE400•RX3i CPE330（需要8.90或更高版本的固件）•RSTi EP CPE10010如果要配置嵌入式PROFINET控制器功能，则必须在LAN2上为RX3i CPU400、CPE330和RSTi EP CPU100配置该功能。对于独立CPU的RX3i CPE400和RSTi EP CPE100，RELIANCE 57401-2这将是其唯一的PROFINET控制器。在CPE330的情况下，嵌入式PROFINET控制器可以与其CPU机架中的任何机架安装PROFINET控制器（IC695PNC001）共存。要在Proficy Machine Edition11的项目中启用嵌入式PROFINET控制器，请在PME Navigator（图1）中选择RX3i CPE400（或CPE330）或RSTi EP CPE100目标，然后打开硬件配置。在“设置”选项卡上，将所选端口的指定LAN模式更改为PROFINET。PROFINET控制器节点描述随后显示所选LAN上存在PROFINET节点。有关更多详细信息，请参阅PACSystems RX3i&RSTi EP PROFINET IO控制器用户手册，GFK-2571G或更高版本。RELIANCE 57401-2
RELIANCE 57401-2 Embedded PROFINET Controller The following CPUs support a feature that permits an Ethernet LAN to be configured for use as a PROFINET Controller: • RX3i CPE400 • Rx3i CPE330 (firmware version 8.90 or later required) RELIANCE 57401-2• RSTi-EP CPE10010 If the Embedded PROFINET Controller feature is to be configured, it must be configured on LAN2 for RX3i CPE400, CPE330 and RSTi-EP CPE100. In the case of RX3i CPE400 and RSTi-EP CPE100, which are Standalone CPU’s, this will be its only PROFINET Controller. In the case of CPE330, the Embedded PROFINET Controller can co-exist with any rack-mounted PROFINET Controllers (IC695PNC001) present in its CPU rack. To enable the Embedded PROFINET Controller in a project in Proficy Machine Edition11, select the RX3i CPE400 (or CPE330) or RSTi-EP CPE100 target in the PME Navigator (Figure 1) and open the Hardware Configuration. On the Settings tab, change the designated LAN Mode of the selected port to PROFINET. The PROFINET Controller node description then displays that a PROFINET node exists on the selected LAN. For further details, refer to the PACSystems RX3i & RSTi-EP PROFINET IO-Controller User Manual, GFK-2571G or later.RELIANCE 57401-2
2.产 品 展 示
3. 主 营 产 品
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
