GE SR745-W3-P5-G5-HI自动化控制模块
1.产 品 详 情 资 料：
检测到F（故障）/红色单元错误。在控制器重置期间由硬件设置。复位后由控制软件控制。R（un）/绿色运行。在控制器重置过程中被硬件清除。复位后由控制软件控制。RxTx1/闪烁时为黄色。以太网包在信道1上发送/接收。RxTx2/闪烁时为黄色。以太网包在信道2发送/接收。PRIM（ary）此LED在单个和冗余配置中亮起。表示主CI867处于冗余配置。DUAL当CI867在冗余配置下运行时，此指示灯亮起。表99。Modbus TCP接口CI867-技术规范项目值类型以太网单元协议Modbus TCP通信速度CH1 10 Mbit/s/100 Mbit/s，在IEEE 802.3u 10/100BaseTx中定义通信速度CH2 10 Mbit/s在IEEE 802.3 10BaseT中定义状态指示灯正常运行：绿色。异常故障：红色。两个交通指示灯——RxTx1和RxTx2——由交通速度控制：闪烁的黄色交通指示灯CH2——RxTx2——由通信速度控制。以初级身份运行：黄色。在冗余配置中运行：黄色。
F(ault) / Red Unit error detected. Set by the Hardware during Controller Reset. Controlled by Control Software after Reset. R(un) / Green Operating. Cleared by the Hardware during Controller Reset. Controlled by Control Software after Reset. RxTx1 / Yellow When flashing. Ethernet packages are sent/received at CH 1. RxTx2 / Yellow When flashing. Ethernet packages are sent/received At CH 2. PRIM(ary) This LED is on in single and redundant configuration. Indicates Primary CI867 in redundant configuration. DUAL This LED is on when CI867 is running in redundant configuration. Table 99. Modbus TCP Interface CI867 - Technical Specification Item Value Type Ethernet unit Protocol Modbus TCP Communication speed CH1 10 Mbit/s / 100 Mbit/s defined in IEEE 802.3u 10/100BaseTx Communication speed CH2 10 Mbit/s defined in IEEE 802.3 10Base-TStatus indicators Running normally: Green. Exceptional fault: Red. Two traffic indictors – RxTx1 and RxTx2 -- controlled by traffic pace: Flashing Yellow Traffic indictor CH2 – RxTx2 - controlled by traffic pace. Running as primary: Yellow. Running in a redundant configuration: Yellow.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4. 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
