RELIANCE DSA-MTR-12A1伺服驱动器
1.产 品 详 情 资 料：
不必完全断开RCU链接电缆，即可更换停止的处理器单元。仅断开备用CPU，从而保持RCU链接电缆连接到主CPU（现在以单一状态运行）。但是，如果必须更换RCU链路电缆，请参阅在线更换有缺陷的RCU链路线缆观察启动过程并确保达到双模式，即两个处理器单元上的双LED均亮起。同步期间，新的处理器单元从正在运行的处理器单元继承IP地址。在同一控制网络内重复使用从冗余配置替换的CPU模块可能会由于MAC和IP地址处理而导致控制网络问题。参见第49页冗余配置中的MAC和IP地址处理。除非已知被替换的模块和先前与其一起在冗余配置中工作的模块从先前的相互地址交换中恢复，否则不应实现这种重用。建议设置IP配置会话，然后使用“恢复出厂设置”选项，然后重新分配IP地址或分配新的IP地址。
You do not have to disconnect the RCU link cables completely in order to exchange a halted processor unit. Disconnect only the backup CPU, thus keeping the RCU link cables connected to the primary CPU (now running in a single state). However, if you must replace the RCU link cables, see Exchanging a Defect RCU Link Cables Online Observe the startup procedure and make sure that Dual mode is reached, that is, the Dual LED is lit on both processor units.During synchronization, the new processor unit inherits the IP address from the running processor unit.Reuse of CPU modules replaced from redundant configurations within the same control network, might cause control network problems due to the MAC and IP address handling. See MAC and IP Address Handling in Redundant Configuration on page 49. Such reuse should not be fulfilled unless both the replaced module and the module previously acting together with it in redundant configuration are known to be restored from the previous mutual address swap. It is recommended to set up an IP-config session and use the “Restore factory settings” option subsequently followed by reassignment of the IP address or assignment of a new IP address.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
