WOODWARD 9907-072电源模块
1.产 品 介 绍
品牌：WOODWARD
型号说明：WOODWARD 9907-072电源模块
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
WOODWARD 9907-072有关PROFIBUS DP和其他合适组件的更多信息，请访问PROFIBUS用户组织网站。请注意，CI851单元没有单元冗余。不能在高完整性控制器中使用。CI851已被CI854通信接口取代。CI851仅出于传统原因进行了描述。不可能通过热插拔更换CI851单元，WOODWARD 9907-072也不允许在包含CI851的系统中执行固件的在线升级。安装基金会现场总线H1接口，WOODWARD 9907-072由处理器单元通过CEX总线供电，因此不需要额外的外部电源。FF H1总线上的现场设备均不由CI852供电。连接到CI852的AC 800M控制器构成基金会现场总线连接设备。使用以下步骤安装CI852/TP852:1。将装置安装到DIN导轨上，请参阅第65页的“将AC 800M装置安装在DIN导轨上”和“以单一配置安装PM86x/TP830处理器装置”WOODWARD 9907-072
For additional information on PROFIBUS DP and other suitable components, visit the PROFIBUS User Organization web site. Note that there is no unit redundancy for the CI851 unit.WOODWARD 9907-072Cannot be used in High Integrity Controller. CI851 has been replaced by the CI854 communication interface. CI851 is only described for legacy reasons. It is not possible to change the CI851 unit via hot swap and it is not allowed to perform an online upgrade of firmware in a system containing CI851.Installing the FOUNDATION Fieldbus H1 Interface,WOODWARD 9907-072 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. No field device on the FF H1 bus is powered from the WOODWARD 9907-072. An AC 800M Controller connected to a CI852 constitutes a FOUNDATION Fieldbus linking device. Use the following procedure to install the CI852/TP852: 1. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single ConfigurationWOODWARD 9907-072
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
