WOODWARD 5501-367数字量输入卡件
1.产 品 介 绍
品牌：WOODWARD
型号说明：WOODWARD 5501-367数字量输入卡件
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
WOODWARD 5501-367基板电缆连接：a.将电源线连接到两个CPU，将电源监控信号从SS8xx连接到螺丝端子SA和SB。将控制网络电缆连接到CN1（单总线连接）或CN1+CN2（冗余总线连接）。控制网络连接到两个CPU。c.使用主CPU的电缆TK212将控制生成器连接到COM4（如果需要更改IP地址等）。否则，将控制生成器与控制网络连接。将光学模块总线连接到处理器单元上的光学触点（参见第32页的图2和第131页的图40）。S800 I/O文档中提供了有关光缆选择和光缆长度的信息。请注意，必须使用RCU链接电缆TK851WOODWARD 5501-367，不能用类似的电缆代替。使用另一根电缆将禁用CB和操作员站中CPU的识别。当以单一配置运行时，RCU链路电缆TK851可能暂时用于执行终端插头的功能。连接到标有“UPPER”的RCU链接电缆连接器的CPU将在控制生成器和操作员站中定义为“UPPER”。标记与CPU的物理位置无关。任何CPU都可以成为主CPU。两个CPU应由同一电源供电（单电源或冗余电源）。有关冗余电源，请参见第140页的图46。与光模块总线的连接与S800 I/O中处理器单元和FCI的连接相同WOODWARD 5501-367
Baseplates cable connections: a. Connect the power leads to both CPUs and the power supervision signals from SS8xx to screw terminals SA and SB Connect the Control Network cables to CN1 (single bus connection) or CN1 + CN2 (redundant bus connection).WOODWARD 5501-367 The Control Network is connected to both CPUs. c. Connect the Control Builder to COM4 with cable TK212 of the Primary CPU (if required for changing an IP address etc.). Otherwise connect the Control Builder to the Control Network.Connect the optical ModuleBus to the optical contacts on the processor units (see Figure 2 on page 32 and Figure 40 on page 131). Information regarding optical cable selection and cable length is provided in the S800 I/O documentation. Note that the RCU Link Cable TK851 must be used and can not be replaced by a similar cable. WOODWARD 5501-367Using another cable will disable the identification of the CPUs in the CB and Operator Station. When running in single configuration the RCU Link Cable TK851 might temporarily be used to perform the function of a termination plug. The CPU connected to the RCU Link Cable connector marked “UPPER” will be defined as “UPPER” in the Control Builder and Operator Station. The marking has no relevance to the physical placement of the CPUs. Any CPU can become the Primary CPU. Both CPUs should be powered from the same supply (single or redundant). For redundant power supply, see Figure 46 on page 140. Connection to the optical ModuleBus is identical to that for the processor unit and for the FCI in S800 I/OWOODWARD 5501-367
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
