WOODWARD 5501-376同步器模块
1.产 品 介 绍
品牌:WOODWARD
型号说明:WOODWARD 5501-376同步器模块
优势:供应进口原装正品,专业停产配件。
公司主营特点:主营产品各种模块/卡件,控制器,触摸屏,伺服驱动器。
2.产 品 详 情 资 料:
如果使用BC810,请将TK851电缆连接到两个BC810(第100页图31)。WOODWARD 5501-376如果未使用BC810,请将CEX总线扩展电缆TK850安装到离处理器单元最远的单元上,如果未安装单元,则直接安装到处理器单元上的CEX总线上WOODWARD 5501-376。无论是否有其他CEX总线单元,CEX总线扩展电缆都必须连接到两个CPU。将RCU链路电缆TK851连接到这两个CPU上。请注意,在冗余CPU配置中,不能使用底板上的COM3和电气模块总线。请注意,必须使用RCU链路电缆TK851,并且不能用类似电缆代替。使用另一根电缆将禁用CB和操作员站中CPU的识别。当以单一配置运行时,RCU链接电缆TK851可能暂时用于执行终端插头的功能。连接到RCU链接线缆连接器的CPU标记为“UPPER”,在控制生成器和操作员站中将被定义为“UPER”。标记与CPU的物理位置无关。任何CPU都可以成为主CPU。WOODWARD 5501-376
If BC810s are used, connect the TK851 cable to the two BC810s (Figure 31 on page 100). WOODWARD 5501-376If no BC810s are used, mount the CEX-Bus extension cable TK850 to the units at farthest away from the processor units or, if no units are mounted, directly to the CEX-Bus on the processor unit.WOODWARD 5501-376 The CEX-Bus extension cable must be connected to both CPUs whether or not there are any other CEX-Bus units Connect the RCU Link Cable TK851 to both CPUs. Note that in redundant CPU configuration, COM3 and the electrical ModuleBus on the baseplate can not be used.Note that the RCU Link Cable TK851 must be used and can not be replaced by a similar cable. Using another cable will disable the identification of the CPUs in the CB and Operator Station. When running in single configuration the RCU Link Cable TK851 might temporarily be used to perform the function of a termination plug.The CPU connected to the RCU Link Cable connector marked “UPPER” will be defined as “UPPER” in the Control Builder and Operator Station. The marking has no relevance to the physical placement of the CPUs. Any CPU can become the Primary CPU.WOODWARD 5501-376
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网,转载请附上此链接:http://www.jiangxidcs.com