WOODWARD 5466-419模块卡件调速器
1.产 品 介 绍
品牌：WOODWARD
型号说明：WOODWARD 5466-419模块卡件调速器
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
COM4端口COM4端口是一个RS-232C端口，光隔离，无调制解调器信号。当直接连接到控制器时，或当不需要时，无需通过控制网络使用远程工具连接，将Control Builder连接到该端口。本主题不适用于冗余配置的WOODWARD 5466-419装置的安装。请参阅以冗余配置安装WOODWARD 5466-419处理器单元在冗余配置中，WOODWARD 5466-419单元安装在两个单独的DIN导轨上。如果有足够的空间，可以将处理器单元安装在同一DIN导轨上。注意，在冗余CPU配置中，不能使用底板上的COM3和电气模块总线。请按照以下步骤沿DIN导轨安装处理器单元：1。安装处理器单元。2.将通信接口安装在处理器单元左侧的CEX总线上。如果使用BC810，则应考虑段的配置。如果没有使用BC810，则可以以任何优选的方式在两个CPU之间划分接口。3.轻轻地将装置压在一起，确保CEX总线通过底板上的连接器正确连接。
COM4 Port The COM4 port is an RS-232C port, opto-isolated and without modem signals. Connect the Control Builder to this port when connecting directly to the controller, or, when not required, without the need use the remote tool connection through the Control Network This topic does not apply to the installation of WOODWARD 5466-419 unit in redundant configuration. See Installing the WOODWARD 5466-419 Processor Unit in Redundant Configuration In redundant configuration WOODWARD 5466-419 units are mounted onto two separate DIN-rails. If sufficient space is available, the units can be mounted onto the same DIN-rail Note that in redundant CPU configuration, COM3 and the electrical ModuleBus on the baseplate can not be used.Use the following procedure to install the processor units along the DIN-rail: 1. Mount the processor units. 2. Mount the communication interfaces on the CEX-Bus to the left of the processor unit. If BC810s are used, the configuration of the segments should be considered. If no BC810s are used, the interfaces can be divided between the two CPUs in any preferred way. 3. Press the units gently together and make sure that the CEX-Bus is correctly connected, via the connectors on the baseplates.
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
