WOODWARD 5466-336自动化控制模块
1.产 品 介 绍
品牌：WOODWARD
型号说明：WOODWARD 5466-336自动化控制模块
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
WOODWARD 5466-336基板电缆连接：a.将电源引线和SS82x的电源监控信号（如适用）连接到螺丝端子SA和SB（参见第83页图28）。b.将控制网络电缆连接到CN1（单连接）或CN1+CN2（冗余连接）。c.将串行协议连接到COM3。d.使用电缆TK212将控制生成器连接到COM4（如果需要更改IP地址等）。否则，将Control Builder连接到控制网络。WOODWARD 5466-3366.将光学模块总线连接到处理器单元上的光学触点（参见第32页的图2和第131页的图40）。S800 I/O文档中提供了有关光缆选择和光缆长度的信息。7.PM8xx配有内部备用电池。使用电池时，将其放在内部电池支架中（参见第193页图63）。使用外部SB821/SB822电池单元时，请按照第143页安装SB821外部电池单元/安装SB822可充电外部电池单元中的说明进行安装WOODWARD 5466-336
Baseplate cable connections: a. Connect the power leads and, if applicable, power supervision signals from SS82x to screw terminals SA and SB (see Figure 28 on page 83). b. Connect the Control Network cables to CN1 (single connection) WOODWARD 5466-336or CN1 + CN2 (redundant connection). c. Connect the serial protocol to COM3. d. Connect the Control Builder to COM4 with cable TK212 (if required for changing an IP address etc). Otherwise connect the Control Builder to the Control Network. 6. Connect the optical ModuleBus to the optical contacts on the processor unit (see Figure 2 on page 32 and Figure 40 on page 131). Information regarding optical cable selection and cable length is provided in the S800 I/O documentation. 7. The PM8xx is supplied with an internal back-up battery. When the battery is to be used, place it in the Internal Battery Holder (see Figure 63 on page 193). When the external SB821/SB822 battery unit is to be used, install it according to the instructions in Installing the SB821 External Battery Unit on page 143/Installing the SB822 Rechargeable External Battery UnitWOODWARD 5466-336
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
