WINGREEN 03ZSTJ1-00-301-RS控制脉冲卡件
1.产 品 介 绍
品牌：WINGREEN
型号说明：WINGREEN 03ZSTJ1-00-301-RS控制脉冲卡件
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
WINGREEN 03ZSTJ1-00-301-RS支持的控制器模块162Bug支持以下VMEbus磁盘/磁带控制器模块。每种控制器类型的默认地址为First address，在命令BH、BO或IOP期间，或在TRAP#15调用.DSKRD或.DSKWR期间，First CLUN可以对控制器进行寻址。请注意，如果使用另一个相同类型的控制器，则第二个控制器的地址必须通过其板载跳线和/或开关进行更改，默认配置说明SCSI通用命令集（CCS）设备是摩托罗拉计算机集团测试的唯一设备。OT命令参数下表列出了与WINGREEN 03ZSTJ1-00-301-RS等板一起使用的软盘的正确IOT命令参数。注释1。除非另有说明，否则所有数值参数均为十六进制。2.DSDD5型软盘是调试器的默认设置。WINGREEN 03ZSTJ1-00-301-RS
Controller Modules Supported The following VMEbus disk/tape controller modules are supported by the 162Bug. The default address for each controller WINGREEN 03ZSTJ1-00-301-RStype is First Address and the controller can be addressed by First CLUN during commands BH, BO, or IOP, or during TRAP #15 calls .DSKRD or .DSKWR. Note that if another controller of the same type is used, the second one must have its address changed by its onboard jumpers and/or switches, so that it matches Second Address and can be called up by Second CLUN.Default Configurations Note SCSI Common Command Set (CCS) devices are the only ones tested by Motorola Computer Group.IOT Command Parameters The following table lists the proper IOT command parameters for floppies used with boards such as the WINGREEN 03ZSTJ1-00-301-RSNotes 1. All numerical parameters are in hexadecimal unless otherwise noted. 2. The DSDD5 type floppy is the default setting for the debugger.
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
