REXROTH MKD090B-047-KG1KN伺服电机
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH MKD090B-047-KG1KN伺服电机
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH MKD090B-047-KG1KN这些规范要求卡导向器底部（相邻导向器之间）的材料高度不超过0.236英寸。不得超过卡导轨的最大材料条件，以适应上述配置中填充有IP的MVME162-4xx板。MVME162FX上的IP安装REXROTH MKD090B-047-KG1KNEmbedded Controller上最多可安装四个IndustryPack（IP）模块。按以下步骤在控制器上安装IP：1。每个IP有两个50针接头，可插入控制器上两个相应的50针接头：J2/J3、J7/J8、J13/J14、J18/J19。连接器位置见图2-1调整仪表板的方向，使锥形连接器外壳正确配合。将IP_a插入接头J2和J3；将IP_b插入J7和J8。将IP_c插入J13和J14；将IP_d插入J18和J19。如果使用双倍大小的IP，请将IP_ab插入J2、J3、J7和J8；将IP_cd插入J13、J14、J18和J19。REXROTH MKD090B-047-KG1KN
These specifications require that the height of the material at the card guide base (between adjacent guides), does not exceed 0.236 inches. This maximum material condition for the card guides must not be exceeded in order to accommodate an REXROTH MKD090B-047-KG1KNboard populated with IPs in the configuration described above. IP Installation on the MVME162FX Up to four IndustryPack (IP) modules may be installed on the MVME162FX Embedded Controller. Install the IPs on the controller as follows: 1. Each IP has two 50-pin connectors that plug into two corresponding 50-pin connectors on the controller: J2/J3, J7/J8, J13/J14, J18/J19. See Figure 2-1 for connector locations. – Orient the IP(s) so that the tapered connector shells mate properly. Plug IP_a into connectors J2 and J3; plug IP_b into J7 and J8. Plug IP_c into J13 and J14; plug IP_d into J18 and J19. If a double-sized IP is used, plug IP_ab into J2, J3, J7, and J8; plug IP_cd into J13, J14, J18, and J19.REXROTH MKD090B-047-KG1KN
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
