Rexroth RMA02.2-32-DC024输入模块
1.产 品 介 绍
品牌:Rexroth
型号说明:Rexroth RMA02.2-32-DC024输入模块
优势:供应进口原装正品,专业停产配件。
公司主营特点:主营产品各种模块/卡件,控制器,触摸屏,伺服驱动器。
2.产 品 详 情 资 料:
Rexroth RMA02.2-32-DC024MPU热调节集管(J23)该集管保留供将来使用。默认出厂配置为未安装跳线的IP总线时钟标头(J24)。此标头选择IP总线时钟的速度。IP总线时钟速度可以是8MHz(在MVME162-4xx和-5xx板上)或32MHz(仅在MVME162-5xx板)。默认出厂配置是在J24上安装跳线,引脚1和2表示8MHz时钟。如果跳线安装在J24上的引脚2和3之间,IP总线时钟与Rexroth RMA02.2-32-DC024总线时钟(32MHz)相同,因此允许IP模块使用32MHz MPU运行。无论设置为8MHz还是32MHz,所有IP端口都以相同的速度运行!警告IP32 CSR位(IP2芯片,偏移$1D处的寄存器,位0)必须设置为与跳线设置相对应。8MHz时清除(0),32MHz时设置(1)。如果跳线和位配置不相同,则电路板可能无法正常运行。Rexroth RMA02.2-32-DC024
MPU Thermal Regulation Header (J23) This header is reserved for future use. Default factory configuration is with no jumper installed IP Bus Clock Header (J24) This header selects the speed of the IP bus clock. The IP bus clock speed may be 8MHz (on both MVME162-4xx and -5xx boards) or 32MHz (on MVME162-5xx boards only). The default factory configuration is with a jumper installed on J24, Rexroth RMA02.2-32-DC024pins 1 and 2 denoting an 8MHz clock. If the jumper is installed on J24, between pins 2 and 3, the IP bus clock is the same as the MC68040 bus clock (32MHz), thus allowing the IP module to run with a 32MHz MPU. Whether the setting is 8MHz or 32MHz, all IP ports operate at the same speed. ! Caution The IP32 CSR bit (IP2 chip, register at offset $1D, bit 0) must be set to correspond to the jumper setting. This is cleared (0) for 8MHz, or set (1) for 32MHz. If the jumper and the bit are not configured the same, the board may not run properly.Rexroth RMA02.2-32-DC024
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网,转载请附上此链接:http://www.jiangxidcs.com