RELIANCE 0-58704接口驱动电路板
1.产 品 介 绍
品牌：RELIANCE
型号说明：RELIANCE 0-58704接口驱动电路板
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
RELIANCE 0-58704控制器前面板上标记为SERIAL PORT 2的DB-25连接器。串行端口2将是EIA232-D DCE或DTE端口，或EIA-530 DCE或DCE端口，或者EIA-485端口，或者是EIA-422 DCE或DTE端口，具体取决于安装的模块。注意端口B在工厂配置为异步通信。对于同步通信，该端口可以连接到DB-25连接器上可能存在的TX和RX时钟信号。这些连接通过控制器上的跨接线头J12进行。TxC和RxC时钟线可通过该板上的接头J15在RELIANCE 0-58704串行端口4上使用，但在其他RELIANCE 0-58704转换模块上不可用。RELIANCE 0-58704转换模块上的以下输出连接器之一：RELIANCE 0-58704:前面板上标记为串行端口4的DB-25连接器。串行端口4可通过MVME712M上的跳线头J18和J19配置为EIA-232-D DTE或DCE端口。RELIANCE 0-58704、AM、-12或-13：前面板上标记为串行端口4的DB-9连接器。串行端口4硬接线为EIA-232-D DTE端口RELIANCE 0-58704
The DB-25 connector marked SERIAL PORT 2 on the front panel of the RELIANCE 0-58704 controller. SERIAL PORT 2 will be an EIA232-D DCE or DTE port, or an EIA-530 DCE or DTE port, or an EIA-485 port, or an EIA-422 DCE or DTE port, depending upon which module is installed.Note Port B is factory configured for asynchronous communication. For synchronous communication, this port can be connected to the TX and RX clock signals which may be present on the DB-25 connector. These connections are made via jumper header J12 on the controller. The TxC and RxC clock lines are available at the RELIANCE 0-58704 SERIAL PORT 4 via header J15 on that board, but are not available on the other RELIANCE 0-58704 transition modules.One of the following output connectors on the MVME712x transition module:RELIANCE 0-58704: The DB-25 connector marked SERIAL PORT 4 on the front panel. SERIAL PORT 4 can be configured as an EIA-232- D DTE or DCE port, via the jumper headers J18 and J19 on the MVME712M. MVME712A, AM, -12, or -13: The DB-9 connector marked SERIAL PORT 4 on the front panel. SERIAL PORT 4 is hard-wired as an EIA-232-D DTE port
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
