RELIANCE 30V4160工控控制卡件
1.产 品 介 绍
品牌：RELIANCE
型号说明：RELIANCE 30V4160工控控制卡件
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
RELIANCE 30V4160磨损仅发生在负载较重的继电器输出和/或使用继电器输出模块时经常切换的继电器输出中。当发生此类磨损时，应将其完全更换，作为预防措施。我们建议每5年更换一次电源内的电解电容器。8.8.1更换缓冲电池的程序锂电池用于缓冲RAM。我们建议大约每2.5年更换一次这些电池。电源监控模块RELIANCE 30V4160：电池：CR-1/2 AA-CB，RELIANCE 30V4160零件号440000016该模块可在电压下拉出。然后，系统警报将被释放，中央模块的显示屏上出现消息BATE（外部缓冲电池故障）。然后拆下电池（第一个正极，然后是负极）。在焊接新电池时，应注意正确的极化，首先焊接负极，然后焊接正极。中央模块：RELIANCE 30V4160零件号440000018模块可能在电压不足时被拉出。对于单通道系统，这会导致设备关闭，在冗余系统中，如果拉出中央模块，系统反应取决于配置。RELIANCE 30V4160
Wear can only occur in relay outputs with heavy loads and/or those which are often switched if relay output modules are used. When wear of this kind occurs they should be completely replaced as a preventive measure. We recommended exchanging electrolytic capacitors within the power supply every 5 years. 8.8.1 Procedure to Exchange the Buffering Batteries Lithium btteries are used to buffer the RAMs. We recommend exchanging of these batteries approx. every 2,5 years. Power supply monitoring module RELIANCE 30V4160: Battery: CR-1/2 AA-CB, HIMA-Part no. 440000016 The module can be pulled out under voltage. Then a system alarm will be released and on the display of the central module the message BATE (fault external buffering battery) occurs. Then unsolder batteries (1st + pole, then - pole). With soldering of the new batteries regard for correct polarization and solder at first the - pole and then the + pole. Central module: RELIANCE 30V4160, HIMA-part no. 440000018 The module may be pulled out under voltage. With single channel systems this results in a shut down of the plant, in redundant systems the system reaction if a central module is pulled out depends on the configuration.RELIANCE 30V4160
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
