RELIANCE 57C405-C远程头输入/输出
1.产 品 介 绍
品牌：RELIANCE
型号说明：RELIANCE 57C405-C远程头输入/输出
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
电源退出：1。检查电源RELIANCE 57C405-C和监控模块RELIANCE 57C405-C上的LED（亮LED指示模块正确，暗LED指示模块有缺陷。仅更换有缺陷的模块，否则关闭PLC！）2。如果LED熄灭，检查24 V直流供电。3.在退出故障电源RELIANCE 57C405-C之前，RELIANCE 57C405-C检查所有其他电源的输出电压，如果是F 7126，必要时将其调整为5.4 V！4.拧下故障电源并将其取出。插入：1。插入电源并用螺钉固定。2.检查输出电压，必要时进行调整。通信模块F 8625退出：1。断开以太网电缆并将其弯曲。2.取下模块的固定螺钉。3.取出模块，连接HSR电缆。4.拆下HSR电缆。插入：1。根据数据表检查设置。2.插入不带电缆的模块并将其固定。连接HSR电缆。4.连接以太网电缆。RELIANCE 57C405-C
Power Supplies Withdraw: 1. Check the LEDs on the power supplies RELIANCE 57C405-C, F 7130A and of the monitoring modulesRELIANCE 57C405-C (luminated LEDs indicate correct modules, dark LED indicates defective module. Change only defective module, otherwise switching off of the PLC!) 2. If the LED is off check the 24 V DC feeding. 3. Before withdrawing the faulty power supplyRELIANCE 57C405-C check the output voltage of all the other power supplies and in case of RELIANCE 57C405-Cadjust it to 5.4 V if necessary! 4. Screw off the faulty power supply and withdraw it. Insert: 1. Insert power supply and fix it by screws. 2. Check the output voltage and adjust it if necessary.Communication Module F 8625 Withdraw: 1. Disconnect the ethernet cable and bend it byside. 2. Remove fixing screws of the module. 3. Withdraw module with HSR cable connected. 4. Remove HSR cable. Insert: 1. Check settings acc. to data sheet. 2. Insert module without cable and fix it. 3. Connect HSR cable. 4. Connect ethernet cable.
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.关 于 相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
