NI PXIe-1065插槽机箱背板
1.产 品 介 绍
品牌：NI
型号：NI PXIe-1065
产品说明：插槽机箱背板
优势：供应进口原装正品，专业停产配件。
2.产 品 详 情 资 料：
NI PXIe-1065用于直接安装到可编程控制器上的串行端口15针D壳体阴螺纹，用于通信电缆安装硬件两个M3螺纹连接器指旋螺钉。建议扭矩：8英寸/磅（0.9牛顿米）。这些都配有隔离器。两个用户提供的#6/32（4mm）螺纹面板安装螺钉。建议扭矩：12英寸/磅（1.4牛顿米）电源典型电流+5VDC（由端口提供）25 mA 100 mA，可用于外部设备接地隔离符合性500 V EIA-422/485平衡线路工作温度0°-60°C（NI PXIe-106532°-140°F）波特率PLC概述系列90-30 PLC支持的那些必须安装在保护外壳中。外壳应能够适当地散热其内部安装的所有设备产生的热量。本附录描述了如何计算90-30系列PLC的散热量。NI PXIe-1065
RS-485 15-pin D shell male for direct mounting to serial port on the programmable controller 15-pin D shell female for communication cable Installation Hardware Two M3 thread connector thumbscrews. Recommended torque: 8 in./lbs. (0.9 Newton-meter). NI PXIe-1065These are supplied with Isolator. Two user supplied #6/32 (4mm) thread panel mounting screws. Recommended torque: 12 in./lbs. (1.4 Newton-meter) Electrical Voltage Supply Typical Current +5VDC NI PXIe-1065(supplied by port) 25 mA 100 mA available for external equipment Ground Isolation Conformance 500 Volts EIA-422/485 Balanced Line Operating Temperature 0° - 60°C (32° - 140° F) Baud Rate Those supported by PLC Overview Series 90-30 PLCs must be mounted in a protective enclosure. The enclosure should be capable of properly dissipating the heat produced by all of the devices mounted inside it. This appendix describes how to calculate heat dissipation for a Series 90-30 PLC.NI PXIe-1065
3.产 品 展 示
4.公 司 优 势
5.关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
