B&R 8BVI0440HWS0.000-1驱动程序
1.产 品 介 绍
品牌：B&R
型号：B&R 8BVI0440HWS0.000-1驱动程序
产品说明：模块卡件
特点：模块/卡件，控制器，触摸屏，伺服驱动器
优势：供应进口原装正品，专业停产配件。
快递方式：国内顺丰、德邦、京东快递包邮，按照实际报价货期发货
2.产 品 详 情 资 料：
B&R 8BVI0440HWS0.000-1驱动程序连接器–37针外螺纹D型，带4-40螺钉，AMP罩编号1-207908-0或同等产品。15针外螺纹D型，带M3螺钉和编号为207908-4的AMP罩或同等产品。AMP接头未配备M3（公制）螺钉。Workmaster II至90系列PLC的多点配置下图显示了将Workmaster II、Workmaster或兼容计算机以8线多点串行数据配置连接至90系列PLCs的接线图和要求。下图是使用B&R 8BVI0440HWS0.000-1转换器时多点配置所需的接线配置示例。注：Series 90-30 PLC中PLC串行端口的连接器必须是直角连接器，以便铰链门关闭正确的带转换器的多点配置示例下图是在计算机中安装工作站接口板时所需的布线配置示例。B&R 8BVI0440HWS0.000-1
Connectors – 37-pinB&R 8BVI0440HWS0.000-1 male D-type with 4-40 screws and AMP hood No. 1-207908-0 or equivalent. 15-pin male D-type with M3 screws and AMP hood No. 207908-4, or equivalent. An AMP connector is not supplied with M3 (metric) screw . Multidrop Configuration, Workmaster II to Series 90 PLCs The following illustrations show the wiring diagram and requirements for connecting a Workmaster II,B&R 8BVI0440HWS0.000-1 Workmaster, or compatible computer to Series 90 PLCs in an 8-wire multidrop, serial data configuration. The figure below is an example of the wiring configuration required for the multidrop configuration when using the RS-422/RS-485 to RS-232 converter. Note The connector to the PLC serial port in the Series 90-30 PLC must be a right angle connector in order for the hinged door to close proper Example of Multidrop Configuration with Converter The following figure is an example of the wiring configuration required when a Work Station Interface board is installed in the computer.B&R 8BVI0440HWS0.000-1
3.产 品 展 示
4.关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
