JUMO ATH-SW-22温控器
产品详情资料：
JUMO ATH-SW-22温控器内部模块诊断指示模块OK（正常）和Configured OK（配置正常）状态的单个LED指示输出1至4 A状态的可拆卸接线板，用于连接现场接线。输入可以用作计数信号或边缘敏感选通信号。输出可用于驱动指示灯、电磁阀、继电器和其他设备。操作模块逻辑电路的电源来自底板底板上的5 VDC总线。输入和输出设备的电源必须由用户或90-30系列电源的+24 VDC隔离输出提供。I/O处理器模块提供可选阈值电压，以允许输入响应5 VDC信号电平或10至30 VDC信号电平。JUMO ATH-SW-22阈值由配置选择。通过内部诊断后，模块的所有配置参数将从PLC下载到I/O处理器。成功配置模块后，CONFIG OK（配置正常）LED将点亮。可使用编程/配置软件或手持式编程器更改配置参数。JUMO ATH-SW-22
Internal module diagnostics Individual LEDs that indicate Module OK and Configured OK status Individual LEDs that indicate state of Outputs 1 through 4 A removable terminal board for connection of field wiring. Inputs can be used as count signals or edge-sensitive strobe signals. Outputs can be used to drive indicating lights, solenoids, relays, and other devices.JUMO ATH-SW-22Power to operate the module’s logic circuitry is obtained from the 5 VDC bus on the baseplate backplane. Power sources for the input and output devices must be supplied by the user or by the +24 VDC isolated output of the Series 90-30 power supply. The I/O Processor module provides a selectable threshold voltage to allow the inputs to respond to either a 5 VDC signal level or a 10 to 30 VDC signal level. The threshold is selected by configuration. All configuration parameters for the module are downloaded from the PLC to the I/O Processor after it passes its internal diagnostics. Once the module has been successfully configured, the CONFIG OK LED will turn on. Configuration parameters can be changed using the programming/configuration software or the Hand-Held Programmer.JUMO ATH-SW-22
品牌：JUMO
型号：JUMO ATH-SW-22
产品说明：温控器
特点：模块/卡件，控制器，触摸屏，伺服驱动器
优势：供应进口原装正品，专业停产配件。
产 品 展 示
关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
