KOLLMORGEN CE10560伺服驱动器电机
产品详情资料：
KOLLMORGEN CE10560伺服驱动器电机I/O LINK主系统配置示例上图显示了一个简单的I/O LINK系统：一个用作主系统的Series 90-30 PLC、一个Series 90-30手持式编程器、一个I/O LINK和一个从系统。在图中，从属设备是Power Mate CNC。其他可用作从设备的设备包括Series 90-70 PLC、KOLLMORGEN CE10560、Fanuc Series 0 CNC、Fanuc连接单元和Fanuc操作员面板。该模块可使用Series 90-30手持式编程器（HHP）或组态软件进行组态。任何数量的I/O LINK主模块均可安装在Series 90-30 PLC中。当同一PLC中有多个I/O LINK主模块时，它们必须位于单独的I/O LINK上。I/O LINK主模块可以安装在任何基板的任何I/O插槽中。可安装在CPU基板上的I/O LINK主模块的最大数量为六个，重新启动按钮如果发生故障，LINK Restart按钮提供了一种方便的重新启动方式。按下重启按钮可重启LINK的操作。串行端口模块的前端有一个20针本田型连接器，用于连接到I/O链路上的第一个从设备。信号电平与RS422/485兼容。KOLLMORGEN CE10560
Example of I/O LINK Master System Configuration The illustration above shows a simple I/O LINK system: a Series 90-30 PLC used as a master, a Series 90-30 Hand-held Programmer, an I/O LINK, and one slave. In the illustration, the slave is a Power Mate CNC. Other devices that can be used as slaves include the Series 90-70 PLC, the Series 90-30 PLC,KOLLMORGEN CE10560 the Fanuc Series 0 CNC, Fanuc Connection Units, and Fanuc Operator Panels. The module can be configured using a Series 90-30 Hand-held Programmer (HHP) or the configuration software.Any number of I/O LINK Master Modules can be installed in a Series 90-30 PLC. When there are multiple I/O LINK Master Modules in the same PLC, they must be on separate I/O LINKs. An I/O LINK Master Module can be installed in any I/O slot in any baseplate. KOLLMORGEN CE10560The maximum number of I/O LINK Master Modules that can be installed in the CPU baseplate is six,Restart Pushbutton The LINK RESTART pushbutton provides a convenient means of restart if a failure occurs. Pushing the Restart pushbutton restarts the operation of the LINK. Serial Port The front of the module has one 20-pin, Honda-type connector, used for connection to the first slave on the I/O LINK. Signal levels are RS422/485 compatible.KOLLMORGEN CE10560
品牌：KOLLMORGEN
型号：KOLLMORGEN CE10560
产品说明：伺服驱动器电机
特点：模块/卡件，控制器，触摸屏，伺服驱动器
优势：供应进口原装正品，专业停产配件。
产 品 展 示
关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
