ABB 751010R0815控制板电源
产品详情资料：
ABB 751010R0815控制板电源手持式编程器可使用90-30系列手持式编程仪（ABB 751010R0815配置GBC。Genius I/O块Genius I/O模块可以与GBC位于同一总线上。但是，由于总线控制器与较旧的A相模块不兼容，因此它们不应安装在同一总线上。Genius总线Genius总线是一条屏蔽双绞线，ABB 751010R0815菊花链连接在设备之间，两端终止。正确的电缆选择对于系统的成功运行至关重要。GEK-90486-1《Genius I/O系统和通信用户手册》中列出了合适的电缆类型。Diagnostics Genius块和总线上的其他设备自动向PLC报告故障、警报和某些其他预定义条件。在任何总线扫描期间只能发送一条诊断消息。如果在该扫描期间（由另一个设备）已经发送了故障消息，则设备将保存自己的诊断消息，直到下一次可用的总线扫描。例如，如果通信令牌当前在设备3处，并且故障同时发生在设备3和4处，则如果尚未发送另一消息，则设备3可以发送其诊断消息。设备4必须至少再等待一次总线扫描才能发送其诊断消息。ABB 751010R0815
Hand-Held Programmer The GBC can be configured using a Series 90-30 Hand-Held Programmer ABB 751010R0815. Genius I/O Blocks Genius I/O blocks can be present on the same bus as the GBC. However, because the Bus Controller is not compatible with older phase A blocks, they should not be installed on the same bus. Genius Bus The Genius bus is a shielded twisted-pair wire, daisy-chained between devices, and terminated at both ends. Proper cable selection is critical to successful operation of the system. Suitable cable types are listed in GEK-90486-1, the Genius I/O System and Communications User’s Manual. Diagnostics Genius blocks and other devices on the bus automatically report faults, alarms and certain other predefined conditions to the PLC.Only one diagnostic message can be ABB 751010R0815sent during any bus scan. If a fault message has already been sent (by another device) during that scan, a device saves its own diagnostic message until the next available bus scan. For example, if the communications token is currently at device 3, and faults occur at devices 3 and 4 at the same time, device 3 can send its diagnostic message if another message has not already been sent. Device 4 must wait at least one more bus scan to send its diagnostic message.
品牌：ABB
型号：ABB 751010R0815控制板电源
产品说明：控制器模块
特点：模块/卡件，控制器，触摸屏，伺服驱动器
优势：供应进口原装正品，专业停产配件。
产 品 展 示
关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
