GE IS215UCVDH5AP控制器模块
产品详情资料：
GE IS215UCVDH5AP控制器模块将电池附件板上的背板连接器与底板背板上的电源连接器对齐。将电池附件板推向基板，直至其完全就位。参见上图。3.如果基板在装运时安装了电池附件板，请确保通过包装材料或电缆扎带将板固定到位。电缆扎带可安装在附件板两端的孔中，并固定在基板上GE IS215UCVDH5AP。注意：为避免丢失CPU数据，必须在关闭PLC电源后1小时内或卸下内存备用电池后20分钟内安装电池附件。有关详细信息，请参阅“超级电容器存储器备份”。卸下电池附件后，必须在20分钟内安装具有良好电池的电源模块和/或输入电源，以避免丢失CPU数据。详见“超级电容器存储器备份”GE IS215UCVDH5AP
GE IS215UCVDH5APAlign the backplane connector on the Battery Accessory board with the power supply connector on the baseplate backplane. Push the Battery Accessory board toward the baseplate until it is fully seated. See the figure above. 3. If the baseplate is to be shipped with the Battery Accessory board installed, ensure that the board is held in place by packing material or cable ties. The cable ties can be installed in holes provided on both ends of the accessory board and secured to the baseplate. Caution To avoid losing CPU data, the Battery Accessory must be installed within 1 hour after turning off PLC power, or 20 minutes after removing the memory backup battery. See GE IS215UCVDH5AP“Super Capacitor Memory Backup” for details. When the Battery Accessory is removed, a power supply module with a good battery must be installed and/or input power applied within 20 minutes to avoid losing CPU data. See “Super Capacitor Memory Backup” for detailsGE IS215UCVDH5AP
品牌：GE
型号：GE IS215UCVDH5AP控制器模块
产品说明：控制器
特点：模块/卡件，控制器，触摸屏，伺服驱动器
产 品 展 示
产 品 展 
公 司 主 营 优 势
应 用 行 业
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
