CAMERON AAP3798102-00130通用显示压缩机控制模块
CAMERON AAP3798102-00130通用显示压缩机控制模块中文资料：
CAMERON AAP3798102-00130通用显示压缩机控制模块使用通用接线板或接线板将接线板安装在控制外壳内，并将屏蔽电缆从接线板连接到模块接线板端子上的每个输入电路。Ŷ将每根电缆的屏蔽连接到接线板旁边的金属面板。不要在模块端连接屏蔽（在电缆模块端切断屏蔽并用热缩管绝缘）。Ŷ用屏蔽电缆将现场设备连接到端子板，仅在设备端接地屏蔽（在电缆的端子板端切断屏蔽并用热缩管绝缘）。此外，应尽可能缩短端子板和设备端的外露（屏蔽外部）引线的长度。直接方法Ŷ将屏蔽电缆从现场设备（传感器、电位计等）直接连接到模块。Ŷ将导体连接到模块端子板上的适用螺钉上。将现场设备端的屏蔽接地，使最小数量的导体暴露在噪声环境中。不要在模块端连接屏蔽（切断电缆模块端的屏蔽并用热缩管绝缘）。CAMERON AAP3798102-00130TBQC不推荐用于模拟模块由于电缆屏蔽要求，端子板快速连接（TBQC）组件不建议用于模拟模块。CAMERON AAP3798102-00130
英文资料
Using a Generic Terminal Block or Strip Ŷ Mount a terminal strip inside the control enclosure and run a shielded cable from the terminal strip to each input circuit on the module’s terminal board terminals. Ŷ Connect each cable’s shield to the metal panel next to the terminal strip. Do not connect the shields at the module end (cut shield off at module end of cable and insulate with shrink tubing). Ŷ Wire the field device to the terminal strip with a shielded cable, grounding the shield at the device end only (cut shield off at terminal strip end of cable and insulate with shrink tubing). Also, keep the length of exposed (outside of shield) leads at the terminal strip and device ends as short as possible. Direct Method Ŷ Run a shielded cable from the field device (transducer, potentiometer, etc.) directly to the module. Ŷ Connect the conductors to the applicable screws on the module’s terminal board.Ground the shield at the field device end, exposing a minimum amount of conductor to the noisy environment. Do not connect the shield at the module end (cut shield off at module end of cable and insulate with shrink tubing). TBQC not Recommended for Analog Modules The Terminal Block Quick Connect (TBQC) Assembly is not recommended for use with analog modules due to cable shielding requirements.CAMERON AAP3798102-00130
每 日 展 示
公 司 主 营 优 势
应 用 行 业
