EPRO PR9268307-100 9200-06121n振动传感器
EPRO PR9268307-100 9200-06121n振动传感器中文资料:
EPRO PR9268307-100 9200-06121n振动传感器注:尽管图2-7显示了塑料基板盖已拆除,但这仅用于说明。无需拆下盖即可安装支架。支架就位后,将两个螺钉(包括在支架中)穿过底板孔的背面插入并拧紧到支架中的螺纹孔中。IC693ACC313嵌入式安装适配器支架。EPRO PR9268307-100 9200-06121n用于在19“机架内凹入安装底板。使用四个8-32(4mm)螺钉、螺母、锁紧垫圈和平垫圈将基板安装在适配器支架的后面板上。适配器支架使用适用的硬件(建议使用锁紧垫圈)通过其四个槽孔螺栓连接到19“机架的表面。注意:为了说明,所示的基板已拆下盖子。安装支架时无需拆下基板盖。图2-7。IC693ACC308前安装适配器支架安装尺寸如下图所示,用于用IC693ACC 308前安装连接器支架机架安装10槽底板。EPRO PR9268307-100 9200-06121n
英文资料
NOTE: Although Figure 2-7 shows the plastic baseplate cover removed, this is for illustration purposes only. It is not necessary to remove the cover to install the bracket. With the bracket in place, insert and tighten the two screws (included with the bracket) through the back of the baseplate holes into the threaded holes in the bracket.IC693ACC313 Recessed Mount Adapter Bracket. Used to recess mount a baseplate inside a 19” rack. A baseplate mounts on the rear panel of this adapter bracket using four 8-32 (4mm) screws, nuts, lock washers, and flat washers. The Adapter Bracket bolts through its four slotted holes to the face of the 19” rack using applicable hardware (lock washers recommended).Note: Baseplate is shown with cover removed for illustration purposes. It is not necessary to remove the baseplate cover to install the bracket. Figure 2-7. IC693ACC308 Front Mount Adapter Bracket Installation Dimensions for rack mounting a 10-slot baseplate with the IC693ACC308 Front Mount Adapter Bracket are shown in the following figure.EPRO PR9268307-100 9200-06121n
每 日 展 示
公 司 主 营 优 势
应 用 行 业