ABB IH532EN 3BSE018795R1通用键盘
ABB IH532EN 3BSE018795R1通用键盘中文资料：
ABB IH532EN 3BSE018795R1通用键盘带固定螺钉的端子板Ŷ拆卸：要拆卸这些端子板，首先松开端子板前面的两个固定螺钉，然后按照“拆卸I/O模块的端子板”一节中的标准拆卸说明进行操作。固定螺钉固定在端子板中，不必完全拆卸。Ŷ安装：要安装这些端子板，请遵循“安装I/O模块的端子板”一节中的标准安装说明，然后将两个固定螺钉拧紧至8至10英寸磅（1牛顿米）的扭矩。确保遵循本章中的基板接地说明。PLC未正确接地可能导致操作不当、设备损坏和人员受伤。ABB IH532EN 3BSE018795R1使用四个质量良好的8-32 x 1/2（4 x 12mm）机器螺钉、锁紧垫圈和平垫圈将基板安装到面板上。将螺钉安装在四个螺纹孔中。“基板”一章具有适用的尺寸和安装间隙。或者，可以使用适当的适配器将10槽底板安装在标准的19英寸机架中。这也在“基板”一章中讨论。ABB IH532EN 3BSE018795R1
英文资料
Terminal Board with Holding Screws Ŷ Removing: To Remove these terminal boards, first loosen the two holding screws on the front of the terminal board, then follow the standard removal instructions in the section “Removing an I/O Module’s Terminal Board.” The holding screws are held captive in the terminal board and do not have to be completely removed. Ŷ Installing: To install these terminal boards, follow the standard installation instructions in the section “Installing an I/O Module’s Terminal Board,” then tighten the two holding screws to 8 to 10 inch-pounds (1 Newton-meter) of torque.Be sure to follow baseplate grounding instructions in this chapter. Failure to properly ground the PLC can result in improper operation, damage to equipment, and injury to personnel. Mounting a Baseplate to a Panel Ŷ Use four good-quality 8-32 x 1/2 (4 x 12mm) machine screws, lock washers and flat washers. Install the screws in four tapped holes. The “Baseplates” chapter has the applicable dimensions and mounting clearances. Alternately, 10-slot baseplates can be mounted in standard 19-inch racks by using the appropriate adapter. This is also discussed in the “Baseplates” chapter.ABB IH532EN 3BSE018795R1
每 日 展 示
公 司 主 营 优 势
应 用 行 业
