ABB IIMPM02系统模块卡件
ABB IIMPM02系统模块卡件中文资料：
ABB IIMPM02系统模块卡件卸下模块的端子板要卸下端子板：Ŷ打开塑料端子板盖。Ŷ向上推顶杆以释放接线板。顶杆Ŷ抓住拉片并将其拉向您，直到触点与模块外壳分离，底部枢轴钩已脱离I/O模块端子板接线柱端子板左侧有三个接线柱。顶柱和底柱将端子板盖固定到位。中间接线柱将端子板接线固定到位。如果您不需要它将接线固定到位，中间接线柱可以很容易地折断。ABB IIMPM02（如果您需要它来保持接线，请注意不要无意中折断。）。)安装和卸下带有固定螺钉的端子板离散输出模块IC693MDL730F（及更高版本）和IC693MDL 731F（及更新版本）有一个配备固定螺钉的特殊端子板，如下图所示。在PLC受到严重振动的应用中，这些螺钉可防止端子板与模块的连接恶化。ABB IIMPM02
英文资料
Removing a Module’s Terminal Board To remove a terminal board: Ŷ Open the plastic terminal board cover. Ŷ Push up on the jacking lever to release the terminal block. JACKING LEVER Ŷ Grasp pull-tab and pull it towards you until contacts have separated from module housing and bottom pivot hook has disengaged I/O Module Terminal Board Posts The terminal board has three posts on the left side. The top and bottom posts hold the terminal board cover in place. The middle post keeps the terminal board wiring in place. If you do not require it to hold the wiring in place, the middle post can be easily snapped off. (Be careful that you do not inadvertently snap it off if you need it to keep your wiring in place.) Installing and Removing Terminal Boards with Holding Screws Discrete output modules IC693MDL730F (and later) and IC693MDL731F (and later) have a special terminal board that is equipped with holding screws, shown in the figure below. These screws prevent the terminal board-to-module connections from deteriorating in applications where the PLC is subjected to severe vibration .ABB IIMPM02
每 日 展 示
公 司 主 营 优 势
应 用 行 业
