ABB IIMKM02工控模块卡件
ABB IIMKM02工控模块卡件中文资料：
ABB IIMKM02工控模块卡件请勿在通电的情况下插入或移除模块。这可能导致PLC停止或故障。可能导致人员受伤和模块或基板损坏。即使机架的电源已关闭，模块的螺丝端子上也可能存在来自用户设备的潜在危险电压。在处理模块的可拆卸端子板或与其连接的任何电线时，必须小心。ABB IIMKM02Ŷ如果模块有接线，请移除模块的端子板（注：不必解开端子板）或电缆。本节稍后将介绍拆除接线板的步骤。Ŷ将释放杆定位在模块底部，并朝模块方向用力向上按压。Ŷ将模块牢牢固定在其顶部并完全按下释放杆时，向上摆动（枢转）模块（释放杆必须脱离其固定槽）。Ŷ通过向上移动模块并使其远离基板，来分离模块顶部后部的枢轴钩。如果首先从扩展或远程基板上卸下电源，则可在PLC处于运行模式时添加、移除或更换扩展或远程底板中的模块。断电时，此基板的I/O数据不会更新。ABB IIMKM02
英文资料
Do not insert or remove modules with power applied. This could cause the PLC to stop or malfunction. Injury to personnel and damage to the module or baseplate may result. Also potentially dangerous voltages from user devices may be present on a module’s screw terminals even though power to the rack is turned off. Care must be taken any time that you are handling the module’s removable terminal board or any wires connected to it. Ŷ If the module has wiring, remove the module’s terminal board (NOTE: You do not have to unwire the terminal board) or cables. The procedure for removing a terminal board is described later in this section. Ŷ Locate the release lever at the bottom of the module and firmly press it up, towards the module. Ŷ While holding the module firmly at its top and fully depressing release lever, swing (pivot) the module upward (release lever must be free of its retaining slot). Ŷ Disengage pivot hook at the top rear of the module by moving the module up and away from the baseplate.Modules in expansion or remote baseplates can be added, removed, or replaced while the PLC is in RUN mode if power is first removed from the expansion or remote baseplate. I/O data to/from this baseplate will not be updated while power is removed.ABB IIMKM02
每 日 展 示
公 司 主 营 优 势
应 用 行 业
