Mitsubishi MR-J2S-350B-EG171伺服驱动器
Mitsubishi MR-J2S-350B-EG171原点指定平面的原点。Axis1指定平面的第一个轴。Axis2指定平面的第二个轴。SensedPart指定与平面传感器相交的部分。如果多个零件相交，则会选择布局浏览器中首先列出的零件。激活指定PlaneSensor是否处于激活状态。如果传感器与物体相交，则传感器输出为True。位置传感器位置传感器监测物体的位置和方向。注意！对象的位置和方向仅在模拟期间更新对象指定要监视的对象。参照指定参照坐标系（父坐标系或全局坐标系）。ReferenceObject指定引用对象（如果“引用”设置为“对象”）。Mitsubishi MR-J2S-350B-EG171位置指定对象相对于参考的位置。方向指定相对于Reference.ClostObject的方向（Euler ZYX）ClosestObject定义引用对象或引用点。设置“执行”信号后，组件将查找“最近对象”、“最近部分”和到参考对象的距离，如果未定义参考对象，则查找到参考点的距离。如果定义了RootObject，则搜索仅限于该对象及其子对象。完成并更新相应的财产后，将设置Executed信号。
Mitsubishi MR-J2S-350B-EG171伺服驱动器
Origin Specifies the origin of the plane. Axis1 Specifies the first axis of the plane. Axis2 Specifies the second axis of the plane. SensedPart Specifies the part that intersects the PlaneSensor. If several parts intersect, then the one listed first in the Layout browser is selected.Active Specifies if the PlaneSensor is active or not. SensorOut True if the sensor intersects with an object.PositionSensor The PositionSensor monitors the position and orientation of an object. NOTE! The position and orientation of an object is updated only during the simulation Object Specifies the object to monitor. Reference Specifies the reference coordinate system (Parent or Global). ReferenceObject Specifies the reference object, if Reference is set to Object. Position Specifies the position of the object relative to Reference. Orientation Specifies the orientation (Euler ZYX) relative to Reference.ClosestObject The ClosestObject defines a Reference object or a Reference point. When the Execute signal is set, the component finds the ClosestObject, ClosestPart, and the Distance to the reference object, or to the reference point if the reference object is undefined. If RootObject is defined, the search is limited to that object and its descendants. When finished and the corresponding properties are updated the Executed signal is set.Mitsubishi MR-J2S-350B-EG171
公司主营优势
应用行业
