TRICONEX 4000093-110N控制系统配件
对固定IP地址使用以下设置：有关如何设置PC网络连接的详细信息，请参阅Windows有关配置TCP/IP的帮助。注意！如果电脑已经有来自另一个控制器或以太网设备的IP地址，则自动获取IP地址可能会失败。要确保在电脑之前连接到以太网设备时获得正确的IP地址，请执行以下操作之一：•在连接到控制器之前重新启动电脑。•将电脑连接到控制器后，从命令提示符运行命令ipconfig/renew。远程网络连接要启用到远程子网或本地网络上的控制器的连接，必须允许相关网络流量通过PC和控制器之间的任何防火墙。防火墙必须配置为接受从PC到控制器的以下TCP/IP流量：•UDP端口5514（单播）•TCP端口5515•被动FTP
Use the following settings for a fixed IP address:For detailed information about how to set up the PC network connection, see Windows help
on configuring TCP/IP.NOTE!
Obtaining an IP address automatically might fail if the PC already has an IP address from
another controller or Ethernet device.
To ensure that you get a correct IP address if the PC was previously connected to an Ethernet
device, do one of the following:
• Restart the PC before connecting to the controller.
• Run the command ipconfig /renew from the command prompt after connecting
the PC to the controller.
Remote network connection
To enable a connection to a controller on a remote subnet or over the local network, the
relevant network traffic must be allowed through any firewalls between the PC and the
controller.
The firewalls must be configured to accept the following TCP/IP traffic from the PC to the
controller:
• UDP port 5514 (unicast)
• TCP port 5515
• Passive FTP
