FANUC A06B-6121-H075伺服放大器
1是可能的。耦合组件(链接设备)用于将PA总线集成到PROFIBUS DP网络中。这确保通过完整的PROFIBUS系统(DP和PA)在连续连接的网络中提供所有信息。PROFIBUS DP通过AC800M中的PROFIBUS DP-V1模块CI854/CI854A与IEC61131控制器AC 800M连接。对于高可用性,支持冗余。PROFIBUS的配置是通过Control Builder M完成的。配置包括硬件树中硬件单元的规划以及主设备和从设备的设备特定配置。设备特定配置数据在设备制造商提供的设备特定GSD文件中描述。为了允许在Control Builder M中配置设备,必须将GSD文件转换为HWD文件并插入到项目中。转换使用GSD导入工具完成。
1 are possible.
Coupling components (Linking Devices) are used to integrate PA bus lines into the
PROFIBUS DP network. This ensures that all information is available in a
continuously connected network through the complete PROFIBUS system (DP and
PA).The PROFIBUS DP is interfaced to the IEC61131 controller AC 800M using the
PROFIBUS DP-V1 module CI854/CI854A in the AC800M. For high availability
redundancy is supported.
The configuration for the PROFIBUS is done with the Control Builder M. The
configuration covers the planning of the HW units in the HW tree and the device
specific configuration for the master and slave units as well. The device specific
configuration data is described within the device specific GSD File provided by the
manufacturer of the device. To allow the configuration of the device within the
Control Builder M the GSD File has to be converted to a HWD File and inserted to
the project. The conversion is done with the GSD Import Tool.