ABB ASE2UDC920AE01 3BHB022793R0001模块
按照以下步骤将PMC安装到MVME7100板上。安装程序阅读所有注意事项并按照这些步骤在底板上安装PMC。产品损坏在通电的情况下插入或移除模块可能会损坏模块组件。在安装或删除其他设备或模块之前，请阅读产品附带的文档。使用ESD腕带损坏电路静电放电和不正确的安装和拆卸会损坏电路或缩短其寿命。在接触电路板或电子元件之前，请确保您在ESD安全环境中工作。在手腕上系上ESD腕带。将ESD带的另一端连接到机箱作为接地。在整个手术过程中，ESD带必须固定在手腕和地面上。2.从前面板上卸下PCI填充物。3.将PMC模块的边缘连接器从后面滑入前面板开口，并将PMC模块放在底板顶部。PMC模块下侧的四个接头应与MVME7100上的相应接头顺利连接。
Follow these steps to install a PMC onto the MVME7100 board. Installation Procedure Read all notices and follow these steps to install a PMC on the baseboard.Product Damage Inserting or removing modules with power applied may result in damage to module components. Before installing or removing additional devices or modules, read the documentation that came with the product. Use ESD Wrist Strap Damage of Circuits Electrostatic discharge and incorrect installation and removal can damage circuits or shorten their life. Before touching the board or electronic components, make sure that you are working in an ESD-safe environment.1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure. 2. Remove the PCI filler from the front panel. 3. Slide the edge connector of the PMC module into the front panel opening from behind and place the PMC module on top of the baseboard. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors on the MVME7100.
