B&R 2DS100.60-1输出模块
电缆和连接器产品损坏模块上的RJ-45连接器是双绞线以太网（TPE）或E1/T1/J1网络接口。将E1/T1/J1线路连接到以太网连接器可能会损坏系统。 确保工作区域附近的TPE连接器明确标记为网络连接器 验证连接到TPE套管的电缆长度不超过100米 确保系统的TPE套管仅连接到安全超低电压电路（SELV电路）。如果有疑问，请咨询系统管理员。电池板/系统损坏锂电池的错误更换可能导致危险爆炸。更换车载锂电池时，确保新旧电池型号完全相同。如果没有相应的电池型号，请联系您当地的SMART EC销售代表，以获得官方认可的替代电池型号。数据丢失交换电池可能会导致时间设置丢失。备用电源可防止交换过程中数据丢失。快速更换电池可以节省时间设置。
Cabling and Connectors Product Damage RJ-45 connectors on modules are either twisted-pair Ethernet (TPE) or E1/T1/J1 network interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage your system. Make sure that TPE connectors near your working area are clearly marked as network connectors Verify that the length of an electric cable connected to a TPE bushing does not exceed 100 meters Make sure the TPE bushing of the system is connected only to safety extra low voltage circuits (SELV circuits) If in doubt, ask your system administrator.Battery Board/System Damage Incorrect exchange of lithium batteries can result in a hazardous explosion. When exchanging the onboard lithium battery, make sure that the new and the old battery are exactly the same battery models. If the respective battery model is not available, contact your local SMART EC sales representative for the availability of alternative, officially approved battery models. Data Loss Exchanging the battery can result in loss of time settings. Backup power prevents the loss of data during exchange. Quickly replacing the battery may save time settings.
