REXROTH DKC02.3-040-7-FW伺服控制器模块
PQM开关输入需要激活来自PQM开关公共端子的信号。配置为脉冲计数器的PQM可与双线脉冲启动器一起使用。脉冲启动器必须提供干触点操作。PQM的开关公共端子连接到脉冲启动器的K端子。分配给计数脉冲的PQM开关输入可以连接到脉冲启动器的Y或Z端子，这取决于脉冲启动器的操作，即打开或关闭。必须分配PQM脉冲输入（值）以匹配脉冲启动器的脉冲值，即，如果脉冲启动器每100kWh提供一次干触点闭合，则PQM脉冲输出（值）也必须设置为100。必须考虑与PQM开关输入相关的各种操作参数。PQM开关输入需要至少100ms的操作时间才能检测到。接触操作的持续时间可能不确定
The PQM Switch Inputs require a signal from the PQM Switch Common terminal to be activated. The PQM configured as a Pulse Counter can be used with Two-Wire Pulse Initiators. The Pulse Initiator must provide a dry contact operation. The Switch Common terminal of the PQM is connected to the K terminal of the Pulse Initiator. The PQM Switch Input assigned to count pulses can be connected to the Y or the Z terminal of the Pulse Initiator, depending on the operation of the Pulse Initiator, i.e. OPEN or CLOSED. The PQM Pulse Input (Value) must be assigned to match the pulse value of the Pulse Initiator, i.e if the Pulse Initiator delivers a dry contact closure for every 100kWh, the PQM Pulse Input (Value) must also be set to 100. Various operating parameters with regard to the PQM Switch Inputs must be taken into account. The PQM Switch Inputs require a minimum 100ms operation time to be detected. The duration of the contact operation can be indefinite
