GE DS200EXDEG1A燃机系统燃机卡
访问数据日志中数据的最简单方法是读取整个日志，并将该数据导出到电子表格中进行分析（这是EnerVista PQM设置所采用的方法）。这需要定义要读取的块，从块0开始，读取块内64个寄存器中的每个寄存器中的所有128字节数据。然后定义块1、2、3等，并重复读取每个块的64个寄存器，直到块511。这需要512次读取，每次读取128字节。然后可以基于参数配置来解释数据。在运行填充模式下使用2个数据日志解释数据日志信息，数据日志配置如下：块0和1保留用于数据记录器数据间隔信息。块2包含两个数据日志的标题信息。块2的前32个寄存器保留用于数据日志1报头信息，块2的剩余32个寄存器预留用于数据日志2报头信息。
The easiest way to access the data in the Data Log is to read the entire log and export this data into a spreadsheet for analysis (this is the method incorporated by EnerVista PQM Setup). This requires defining the Block to be read, starting at Block 0, and reading all 128 bytes of data in each of the 64 Registers within the Block. You would then define Blocks 1,2,3 etc. and repeat the reading of the 64 Registers for each block, until Block 511. This requires 512 reads of 128 bytes each. The data can then be interpreted based upon the parameter configuration. INTERPRETING THE DATA LOG INFORMATION Using 2 Data Logs in the Run to Fill mode, the Data Log is configured as follows: Blocks 0 and 1 are reserved for Data Logger Data Interval information. Block 2 contains the Header information for both Data Logs. The first 32 registers of Block 2 are reserved for Data Log 1 Header Information, and the remaining 32 registers of Block 2 are reserved for Data Log 2 Header Information.
