GE DS200TCQAG1B CPU模块
数据日志2：请参阅上文数据日志1的描述，并用数据日志2替换数据日志1中的所有引用。PQM事件记录器连续运行，并记录每个事件发生时的数量、原因、时间、日期和计量量。该数据存储在非易失性存储器中，当PQM断电时不会丢失。必须在S1 PQM设置\事件记录器\事件记录器操作中启用事件记录器。可以在S1 PQM SETUP\CLEAR DATA\CLEAR Event RECORD中清除事件记录器。存储40个最近事件的数据。旧事件的事件数据丢失。注意，事件编号、原因、时间和日期在下表所示的消息中可用，但相关的计量数据只能通过串行通信获得。为POWER OFF事件存储的事件数据不反映断电时的值。event RECORDS-event NUMBER、event CAUSE、time、DATE：这些消息显示事件记录器记录的40个最新事件。
DATA LOG 2: See DATA LOG 1 description above and replace all references to DATA LOGGER 1 with DATA LOGGER 2.The PQM Event Recorder runs continuously and records the number, cause, time, date, and metering quantities present at the occurrence of each event. This data is stored in nonvolatile memory and is not lost when power to the PQM is removed. The Event Recorder must be enabled in S1 PQM SETUP \ EVENT RECORDER \ EVENT RECORDER OPERATION. The Event Recorder can be cleared in S1 PQM SETUP \ CLEAR DATA \ CLEAR EVENT RECORD. Data for the 40 most recent events is stored. Event data for older events is lost. Note that the event number, cause, time, and date is available in the messages as shown in the following table, but the associated metering data is available only via serial communications. The event data stored for POWER OFF events does not reflect values at the time of power-off.EVENT RECORDS- EVENT NUMBER, EVENT CAUSE, TIME, DATE: These messages display the 40 most recent events recorded by the event recorder.
