INDRAMAT TVD1.3-08-03伺服驱动器
•图4–38：设定值第5页–测试/开关输入模拟•模拟：输入ON从实际开关输入切换到编程模拟开关。模拟完成后，将此设定点设置为OFF。•SIMULATION ENABLED FOR（模拟启用时间）：选择将启用模拟的所需时间长度。编程时间过去后，开关输入模拟将关闭。如果选择了UNLIMITED（未限制），则将使用模拟开关输入，直到通过模拟开/关设定点或通过串行端口关闭模拟，或直到PQM中的控制电源断开。•开关输入A/B/C/D：输入要模拟的开关输入状态（打开或关闭）。4.6.6仅供工厂使用•维修密码：这些信息仅供GE Multilin人员访问，仅用于测试和维修。
•FIGURE 4–38: Setpoints Page 5 – Testing / Switch Inputs Simulation • SIMULATION: Enter ON to switch from actual switch inputs to the programmed simulated switches. Set this setpoint OFF after simulation is complete. • SIMULATION ENABLED FOR: Select the desired length of time that simulation will be enabled. When the programmed time has elapsed, switch input simulation will turn off. If UNLIMITED is selected, the simulated switch inputs will be used until simulation is turned off via the simulation on/off setpoint or via the serial port or until control power is removed from the PQM. • SWITCH INPUT A / B / C / D: Enter the switch input status (open or closed) to be simulated. 4.6.6 Factory Use Only • SERVICE PASSCODE: These messages are for access by GE Multilin personnel only for testing and service.
