KEBA E-8-THERMO/A控制卡
如果安装了控制选项，并且其中一个开关分配给SETPOINT ACCESS（设定点访问），则设定点访问开关和软件设定点访问将作为逻辑and（与）。也就是说，在启用设置点访问之前，必须满足这两个条件。假设设定点访问开关激活设置为关闭，则根据按下存储键时出现的条件，将显示以下闪烁消息。]]设置点]]S1 PQM设置]COM1 RS485]串行端口MODBUS通信地址：1 COM1波特率：9600波特率COM1奇偶性：无]]设置点]]S2系统设置设置点范围：1至255；步骤1范围：1200、2400、4800、9600、19200范围：无、偶数、奇数]首选项]]设置点访问]]COM2 RS485]串行端口COM2波特率：9600 BAUD COM2奇偶性：无]前面板RS232]串行端口RS232波特率：96000 BAUD RS232奇偶性：NONE MODBUS通信地址：为PQM输入1到255之间的唯一地址。所选地址用于所有三个串行通信端口。用地址0发送的消息是一条广播消息，所有PQM都将侦听该消息，但不响应
If the control option is installed and one of the switches is assigned to SETPOINT ACCESS, the setpoint access switch and the software setpoint access will act as a logic AND. That is, both conditions must be satisfied before setpoint access will be enabled. Assuming the setpoint access switch activation is set to closed, the following flash messages will appear depending upon the condition present when the store key is pressed. ]] SETPOINTS ]] S1 PQM SETUP ] COM1 RS485 ] SERIAL PORT MODBUS COMMUNICATION ADDRESS: 1 COM1 BAUD RATE: 9600 BAUD COM1 PARITY: NONE ]] SETPOINTS ]] S2 SYSTEM SETUP SETPOINT Range: 1 to 255; Step 1 Range: 1200, 2400, 4800, 9600, 19200 Range: NONE, EVEN, ODD ] PREFERENCES ] ] SETPOINT ACCESS ] ] COM2 RS485 ] SERIAL PORT COM2 BAUD RATE: 9600 BAUD COM2 PARITY: NONE ] FRONT PANEL RS232 ] SERIAL PORT RS232 BAUD RATE: 9600 BAUD RS232 PARITY: NONE MODBUS COMMUNICATION ADDRESS: Enter a unique address from 1 to 255 for the PQM. The selected address is used for all three serial communication ports. A message sent with address 0 is a broadcast message to which all PQMs will listen but not respond
转载请附上此链接：http://www.jiangxidcs.com/
