HIEE200072R0002 DCS工控模块备件
手册第2节GFK-2224Y 2019年8月安装和启动：RX3i/RSTi EP嵌入式接口23 2.1.1.2 CPE330以太网LED操作LED状态操作状态LINK（上）亮绿色相应链路已物理连接。在相应端口检测到闪烁的绿色流量。关闭在相应端口未检测到连接。1 Gbps（更低）琥珀色（LAN1）或相应的网络数据速度为1 Gbps。打开绿色（LAN2）关闭相应的网络数据速度为100 Mbps或10 Mbps。2.1.1.3 CPE400/CPL410前面板以太网LED操作（LAN1、LAN2、LAN3）LED状态操作状态链路状态（上部）亮绿色已建立相应的链路。在相应端口检测到闪烁的绿色流量。关闭在相应端口未建立连接。链路速度（较低）打开绿色相应数据速度为1 Gbps或100 Mbps。关闭相应的网络数据速度为10 Mbps 2.1.1.4 CPE400 Underside Ethernet LED Operation（EFA）LED State Operating State Link Status（上部）On Green（绿色）相应的链路已建立。在相应端口检测到闪烁的绿色流量。PACSystems™ RX3i和RSTi EP TCP/IP以太网通信用户手册第2节GFK-2224Y 2019年8月安装和启动：RX3i/RSTi EP嵌入式接口24 LED LED状态工作状态关闭相应端口未建立连接。链路速度（较低）打开绿色相应网络数据速度为1 Gbps。仅在黄色EFA端口上：网络数据速度为100 Mbps关闭对应的网络数据速度是10 Mbps 2.1.1.5 CPL410 Underside Ethernet LED Operation（ETH）LED State Operating State Link Status（上部）On Green（绿色）对应的链路已建立。在相应端口检测到闪烁的绿色流量。关闭在相应端口未建立连接。链路速度（较低）打开绿色相应网络数据速度为1 Gbps。仅在黄色GPOS端口上：网络数据速度为100 Mbps关闭对应的网络数据速度是10 Mbps 2.1.1.6 CPE100/CPE115以太网LED操作（LAN1，LAN2）LED状态操作状态链路速度（上）琥珀色对应的数据速度是100 Mbps。关闭相应的网络数据速度为10 Mbps链路状态（较低）打开绿色相应的链路已建立。在相应端口检测到闪烁的绿色流量。关闭在相应端口未建立连接。PACSystems™ RX3i和RSTi EP TCP/IP以太网通信用户手册第2节GFK-2224Y 2019年8月安装和启动：RX3i/RSTi EP嵌入式接口25 2.1.2模块安装有关CPU模块和系统的一般信息
Manual Section 2 GFK-2224Y August 2019 Installation and Start-up: RX3i/RSTi-EP Embedded Interface 23 2.1.1.2 CPE330 Ethernet LED Operation LED LED State Operating State LINK (upper) On Green The corresponding link is physically connected. Blinking Green Traffic is detected at the corresponding port. Off No connection detected at corresponding port. 1 Gbps (lower) On Amber (LAN1) or Corresponding network data speed is 1 Gbps. On Green (LAN2) Off Corresponding network data speed is 100 Mbps or 10 Mbps. 2.1.1.3 CPE400/CPL410 Front Panel Ethernet LED Operation (LAN1, LAN2, LAN3) LED LED State Operating State Link Status (upper) On Green The corresponding link has been established. Blinking Green Traffic is detected at the corresponding port. Off No connection established at corresponding port. Link Speed (lower) On Green Corresponding data speed is 1 Gbps or 100 Mbps. Off Corresponding network data speed is 10 Mbps 2.1.1.4 CPE400 Underside Ethernet LED Operation (EFA) LED LED State Operating State Link Status (upper) On Green The corresponding link has been established. Blinking Green Traffic is detected at the corresponding port. PACSystems™ RX3i and RSTi-EP TCP/IP Ethernet Communications User Manual Section 2 GFK-2224Y August 2019 Installation and Start-up: RX3i/RSTi-EP Embedded Interface 24 LED LED State Operating State Off No connection established at corresponding port. Link Speed (lower) On Green Corresponding network data speed is 1 Gbps. On Yellow EFA port only: network data speed is 100 Mbps Off Corresponding network data speed is 10 Mbps 2.1.1.5 CPL410 Underside Ethernet LED Operation (ETH) LED LED State Operating State Link Status (upper) On Green The corresponding link has been established. Blinking Green Traffic is detected at the corresponding port. Off No connection established at corresponding port. Link Speed (lower) On Green Corresponding network data speed is 1 Gbps. On Yellow GPOS port only: network data speed is 100 Mbps Off Corresponding network data speed is 10 Mbps 2.1.1.6 CPE100/CPE115 Ethernet LED Operation (LAN1, LAN2) LED LED State Operating State Link Speed (upper) On Amber Corresponding data speed is 100 Mbps. Off Corresponding network data speed is 10 Mbps Link Status (lower) On Green The corresponding link has been established. Blinking Green Traffic is detected at the corresponding port. Off No connection established at corresponding port. PACSystems™ RX3i and RSTi-EP TCP/IP Ethernet Communications User Manual Section 2 GFK-2224Y August 2019 Installation and Start-up: RX3i/RSTi-EP Embedded Interface 25 2.1.2 Module Installation For general information about CPU module and system
