MVME177P-54SE模块备件
地板的设计和建造必须保证对储存物质的渗透率为1 x 10-6 cm/sec或更低；以及（iv）容器的设计和制造必须符合国家认可协会或独立测试实验室制定的一致准则、标准或惯例，并适合于储存的物质和储存条件。本规定不适用于经陈述、标记、认证或销售的符合危险物质运输条件且符合适用联邦要求的容器；以及（v）容器必须存放在稳定位置。如果堆放此类集装箱，则必须将其堆放在稳定的平台或托盘上。（2） 正在运输或在中转区停留不到五天的集装箱，以及在现场停留不超过180天的有轨车和卡车拖车，不受本小节第（1）款的储存要求的限制。（3） 从1996年8月11日开始，容器必须满足以下要求：（i）每个容器必须贴有标签，以识别其内容物；以及（ii）必须为储存在集装箱储存区内的所有集装箱保存库存记录。此类记录必须包括容器的数量和每个容器的内容。598.6地下储罐系统——测试和检查。（a） 辅助设备的测试和检查。自1995年8月11日起，业主或运营商必须按照以下要求检查辅助设备：6 NYCRR第598部分–2015年10月11日第12页，
（1）必须每月检查通风孔、泄压装置、仪表、警报器、防溢流设备、阴极保护监测设备、其他监测设备、警告警报器和安全系统。必须目视检查设备的清洁度、泄漏、腐蚀和可操作性。（2） 必须对自动管线泄漏检测器和阴极系统进行年度测试，以确保设备正常运行，从而保护受腐蚀的储罐或管道。阴极保护系统必须由合格的技术人员进行检查，以确保存在足够的结构到电解质的电位，以防腐蚀。如果任何管线泄漏检测器或阴极保护系统未能提供必要的保护，则必须根据本部分第598.9（a）（2）节采取措施。（b） 地下储罐泄漏检测。从1995年8月11日开始，业主和运营商必须使用以下一种或多种方法检查地下储罐的泄漏情况：（1）如果每月检测到1%的流量加130加仑的泄漏，并且每年进行一次密封性测试，则可以使用库存监控。库存监控必须按照40 CFR第280.43（a）节（见本部分第598.1[j]节）中规定的标准进行。（2） 可以使用压力监测、真空监测、电子监测或手动取样来对双壁罐的间隙空间进行每周监测。（3） 可使用蒸汽井监测开挖区的土壤。
The floor must be designed and constructed so that the permeability to the stored material is 1 x 10-6 cm/sec or less; And (iv) containers must be designed and manufactured in accordance with consistent codes, standards or practices established by the National Accreditation Society or independent testing laboratories, and suitable for the substances and storage conditions being stored. This provision does not apply to containers that are stated, marked, certified, or sold in compliance with the conditions for transportation of hazardous substances and meet applicable federal requirements; And (v) the container must be stored in a stable position. If such containers are stacked, they must be stacked on stable platforms or pallets. (2) Containers that are being transported or remain in the transit area for less than five days, and railcars and truck trailers that remain on site for less than 180 days, are not subject to the storage requirements of paragraph (1) of this subsection. (3) As of August 11, 1996, containers must meet the following requirements: (i) Each container must be labeled to identify its contents; And (ii) must maintain inventory records for all containers stored in the container storage area. Such records must include the number of containers and the contents of each container. 598.6 Underground Storage Tank Systems - Testing and Inspection. (a) Testing and inspection of auxiliary equipment. From August 11, 1995, the owner or operator must inspect the auxiliary equipment in accordance with the following requirements: 6 NYCRR Part 598 – October 11, 2015 Page 12,
(1) Vents, pressure relief devices, instruments, alarms, anti overflow equipment, cathodic protection monitoring equipment, other monitoring equipment, warning alarms and safety systems must be inspected monthly. The equipment must be visually inspected for cleanliness, leaks, corrosion and operability. (2) The automatic line leak detector and cathodic system must be tested annually to ensure proper operation of the equipment to protect the corroded tank or pipeline. The cathodic protection system must be checked by qualified technicians to ensure that there is enough potential from the structure to the electrolyte to prevent corrosion. If any pipeline leakage detector or cathodic protection system fails to provide necessary protection, measures must be taken according to section 598.9 (a) (2) of this part. (b) Leakage detection of underground storage tank. From August 11, 1995, owners and operators must use one or more of the following methods to check the leakage of underground storage tanks: (1) If 1% of the flow plus 130 gallons of leakage is detected every month, and the leak tightness test is conducted once a year, inventory monitoring can be used. Inventory monitoring must be conducted in accordance with the standards specified in 40 CFR Section 280.43 (a) (see 598.1 [j] of this part). (2) The clearance space of the double wall tank can be monitored weekly using pressure monitoring, vacuum monitoring, electronic monitoring or manual sampling. (3) A steam well can be used to monitor the soil in the excavation area.
