PFCL201CE 20.0KN工控备件机器人模块
Terminal capacity area Terminal type AWG/kcmil Conductor capacity I n mm ² Cover – LZM4 3-pole LN4 – LZM4-4 4-pole LN4-4) Phase isolator – LZM4 4-pole LN4-LZM4-4 4-pole LN4-4 cable lug 185 mm ² LZM3 (- 4) 3 and 4-pole LZM4 (- 4) 240 mm ² LN3（-4）LN4（-4）300 mm ² For connection type 25, order LZM4 EATON CA012002EN part number. Price clause number (see notes of price standard package ordered separately) NZM4-XKSA 1 off 266,846 NZM4-4-XKSA 266,847 type includes parts with top or bottom terminals of 3 or 4-pole circuit breakers. Prevent direct contact when using cable lugs, bus bars, flat cable terminals or tunnel terminals. The kit includes a module board, flat braided terminals and tunnel terminals. When the insulating conductor material is used to reach the protection grade: IP1X. The NZM4-XKP 1 off 281595 NZM4-4-XKP 281596 model contains terminal parts located on the top or bottom of a 3 or 4-pole circuit breaker. Included in the link width extension. It cannot be combined with channel terminal NZM4 (- 4) - XKA and rear connection NZM4-XKR. Insulation protection when using cable lugs, bus bars, module boards or flat cable terminals. NZM3-XKS185 Three 260040 NZM3-XKS240 260041 NZM3-XXS300 153186 types contain cable lugs for three pole or four pole switches. Special cable lug, narrow type. 26 Auxiliary contact ordering LZM, M22 -... EATON CA012 2 (- 4) and 3 (- 4), 4 (- 4) 216,376 1 N/C M22-K01 216,378 with 3 m connection L N/C is used together with auxiliary contact:=safety contact part number Price function, through forward opening sequence product number, see separately ordered price IEC/EN 60,947-5-1 N/O=normally open normally closed tripping indication Auxiliary contact (HIA) general tripping indication "+" when voltage is released Overload release or short-circuit release LZM1 (- 4), 2 (- 4) and 3 99 part numbers. Price Standard Packaging Note Note When ordering separately, please refer to the price The following contents can be clamped in the switch: LZM1 - one standard auxiliary contact LZM2 - up to two standard auxiliary contacts M22 - (C) K... LZM3 and LZM4 - up to three standard auxiliary contacts M22 - (B) K... Any combination of auxiliary contact types is possible. Mark on the switch: HIN M22-CK10 20 off For standard package: 216384 M22 - (C) K...: Standard package=20 off M22-CK01 216385 M22-CK11 107940 M22-CK20 107898 M22-CK02 107899 The following contents can be clamped in the switch: LZM1 - one tripping indication auxiliary switch LZM2 - one M22- (B... Any combination of auxiliary contact types of the trip indication auxiliary switch is possible. Mark on the switch: If HIA uses the trip indication auxiliary contact in the fault current block, the N/C contact operates as the N/O contact, and the N/C contact operates as the N/O contact (circuit symbol). 28 Under voltage release Order LZM1, LZM2/3, LZM4 EATON CA012002EN Under voltage release without auxiliary contact When the control voltage drops below 35 – 70% Us, LZM circuit breaker or LN switch disconnector will open without delay. It is used for emergency stop device and emergency stop button. LN1 (- 4) 259434 left switch 208 V 240 V 50/60 Hz NZM1-XU208-240AC side clamp LZM1 (- 4) 24 V 50/60 Hz NZM1-XU24AC 1 disconnect terminal. 259442 380 V – 440 V 50/60 Hz NZM1-XU380-440AC 259444 24 V DC NZM1-XU24DC 259452 with 3 m LZM1 (- 4) 24 V 50/60 Hz NZM1-XUL24AC 1 Disconnect LN1 (- 4) 259462 cable instead of 208 V 240 V 50/60 Hz NZM1-XUL 208-240AC screw 259471 terminal. 380 V – 440 V 50/60 Hz NZM1-XUL380-440AC 259473 24 V DC NZM1-XUL 24DC 259481 is used for rated control voltage Part number Price Standard packaging Precautions Article number, please refer to separately ordered price list V. When the undervoltage release is de energized, it can safely prevent accidental contact with the main contact of the switch when attempting to make. The undervoltage release cannot be installed simultaneously with NZM... - XHHIV... early closing auxiliary contact or NZM... XA... parallel release. D
端子容量区域端子类型AWG/kcmil导体容量I n mm²盖–LZM4 3极LN4–LZM4-4 4极LN4-4）相位隔离器–LZM4 4极LN4-LZM4-4四极LN4-4电缆接线片185 mm²LZM3（-4）3和4极LZM4（-4）240 mm²LN3（-4）LN4（-4）300 mm²连接类型25订购LZM4伊顿公司CA012002EN零件号。价格条款编号（见单独订购的价格标准包注释）NZM4-XKSA 1 off 266846 NZM4-4-XKSA 266847类型包含3或4极断路器顶部或底部端子的零件。在使用电缆接线片、母线、扁平电缆终端或隧道终端时，防止直接接触。套件中包括模块板、扁平编织端子和隧道端子。使用绝缘导体材料达到防护等级时：IP1X。NZM4-XKP 1 off 281595 NZM4-4-XKP 281596型包含位于3或4极断路器顶部或底部的端子零件。包括在连接宽度延伸部分中。不能与通道端子NZM4（-4）-XKA、后部连接NZM4-XKR组合。使用电缆接线片、母线、模块板或扁平电缆端子时的绝缘保护。NZM3-XKS185 3个260040 NZM3-XKS240 260041 NZM3-XXS300 153186型包含用于三极或四极开关的电缆接线片。特殊电缆接线片，窄型。26辅助触点订购LZM，M22-…伊顿公司CA012 2（-4）和3（-4），4（-4）216376 1 N/C M22-K01 216378带有3 m连接L N/C与辅助触点一起使用：=安全触点零件号价格功能，通过正向打开顺序产品号，参见单独订购的价格IEC/EN 60947-5-1 N/O=常开常闭跳闸指示辅助触点（HIA）一般跳闸指示“+”，当电压释放、过载释放或短路释放LZM1（-4）、2（-4）和3 99零件号。价格标准包装注释注释商品编号单独订购时请参阅价格以下内容可夹在开关中：LZM1-一个标准辅助触点LZM2-最多2个标准辅助触头M22-（C）K…LZM3和LZM4-最多3个标准辅助接点M22-（B）K…辅助触头类型的任何组合都是可能的。开关上的标记：HIN M22-CK10 20 off对于标准包：216384 M22-（C）K…：标准包=20 off M22-CK01 216385 M22-CK11 107940 M22-CK20 107898 M22-CK02 107899以下内容可夹在开关中：LZM1-一个跳闸指示辅助开关LZM2-一个M22-（B…跳闸指示辅助开关辅助触点类型的任何组合都是可能的。开关上的标记：HIA如果使用了故障电流块中的跳闸指示辅助触点，则N/C触点作为N/O触点操作，N/C触点则作为N/O触头操作（电路符号）。28欠压释放订购LZM1、LZM2/3、LZM4伊顿公司CA012002EN欠压释放无辅助触点当控制电压降至35–70%Us以下时，LZM断路器或LN开关隔离开关的非延迟断开。用于紧急停止装置和紧急停止按钮一起使用。LN1（-4）259434左侧开关208 V 240 V 50/60 Hz NZM1-XU208-240AC侧的夹具LZM1（-4）24 V 50/60赫兹NZM1-XU24AC 1断开端子。259442 380 V–440 V 50/60 Hz NZM1-XU380-440AC 259444 24 V DC NZM1-XU24DC 259452带3 m LZM1（-4）24 V 50/60赫兹NZM1-XUL24AC 1断开连接LN1（-4）259462电缆，而不是208 V 240 V 50/60 Hz NZM1-XUL 208-240AC螺钉259471终端。380 V–440 V 50/60 Hz NZM1-XUL380-440AC 259473 24 V DC NZM1-XUL 24DC 259481用于额定控制电压零件号价格标准包装注意事项商品编号，请参阅单独订购的价格表V。当欠压脱扣器断电时，可安全防止在试图接通时意外接触开关的主触点。欠压脱扣器不能与NZM…-XHIV…早期闭合辅助触点或NZM…XA…并联脱扣器同时安装。D
