PFCL201CE 20KN机器人模块
容量零件编号价格条款编号，见标准包装注释铜带（订购的铜母线数量价格段x宽度x宽度x单独列出段厚度）厚度mm mm类型后缀和类型包含3或4极断路器顶部或底部断路器侧的零件。带螺纹连接的断路器转换套件。安装在开关壳体内O=顶部安装U=底部安装Ue≥ 525 V AC：使用NZM3（-4）-XKSA盖。与柔性和高度柔性导体套圈一起使用时，请注意使用套圈时的最大端子容量。（2 x）10 x 50 x 1.0（2 x（10 x 50）NZM3-XKV70 1个100514 NZM3-4-XKV70 1个100515型包含3或4极断路器顶部或底部端子的零件。中心钻孔，例如每相最多2个电缆接线片。可安装在带有螺丝终端的断路器上。提供相位隔离器。NZM3（-4）-XKV70电杆中心之间的距离：70 mm。钻孔可用于控制电缆。NZM3-XKA1 1个271459 NZM3-4-XKA1 1个271460 NZM3-XKA 2 1个271461 NZM3-4-XKA2 1个271462型包含3或4极断路器顶部或底部端子的零件。1 x 0.75–2.5 mm²（18–14 AWG）或2 x 0.75–1.5 mm²（18-16 AWG）铜导线的标准控制电路端子。安装在开关外壳外部。与柔性和高柔性导体套圈一起使用。仅当绞合且无套圈时，才能连接最大指定横截面。必须安装盖子NZM3（-4）-XKSA（提供）。请注意最大直径分别为20.5 mm。22.5 mm.20连接类型订购LZM3伊顿公司CA012002EN盖子–LZM3（-4）3极NZM3-XKSA LN3（-4）260045–4极NZM3-4-XKSA 266801最大电缆连接用于零件号。价格区条款编号（见单独订购的价格表）相位隔离器-LZM3（-4）3极NZM3-XKP LN3（-4）100512–4极NZM3-4-XKP 100513铜电缆接线片当使用不带NZM3（-4）XKSA盖的电缆接线片时，必须对其进行绝缘。185 mm²LZM3（-4）、LN3（-4）3和4极NZM3-XKS185 LZM4（-4），LN4（-4）260040 240 mm²NZM3-XKS 240 260041 300 mm²NZM3-XKS300 153186连接类型21订购LZM3伊顿公司CA012002EN 1个1个标准组件注释类型包含3或4极断路器顶部或底部端子的零件。使用电缆接线片、母线或隧道端子时的直接接触绝缘/保护。包括在隧道终端内。使用绝缘导体材料时，连接侧的防护等级为IP1X。1个1个类型包含位于3或4极断路器顶部或底部的端子零件。包括在连接宽度延伸部分中。不能与后部的NZM3（-4）-XKA隧道终端、NZM3（4）-XKR连接结合使用。电缆接线片、母线或编织物连接的绝缘保护。1个类型包含三极或四极开关的电缆接线片。特殊电缆接线片，窄型22连接类型订购LZM4伊顿公司CA012002EN螺纹连接标准设备2孔最大1600 LZM4（-4）三芯和铜芯电缆1 x 120–185 1 x 250–350，带LN4（-4）四极接线片4 x 50–185 4 x 0–350双头螺栓和螺母。最大电缆数
capacities Part no. Price Article no. when see Std. pack Notes Cu strip (number of Copper busbar ordered price segments x width x width x separately list segment thickness) thickness mm mm Type suffix and type contain parts for a circuit-breaker side at top or bottom for 3 or 4-pole circuit-breakers. Conversion kit for circuit-breaker with screw connection. Fitted within the switch housing O = for fitting at the top U = for fitting at the bottom Ue ≥ 525 V AC: Use NZM3(-4)-XKSA cover. Use with flexible and highly flexible conductors ferrules, note the max. terminal capacity when using ferrules. (2 x) 10 x 50 x 1.0 (2 x) 10 x 50 NZM3-XKV70 1 off 100514 NZM3-4-XKV70 1 off 100515 Type contains parts for a terminal located at top or bottom for 3 or 4 pole circuitbreakers. Central drill holes, e.g. for up to 2 cable lugs per phase. Can be fitted to circuit-breaker with screw termination. Phase isolator supplied. Distance between pole centres with NZM3(-4)-XKV70: 70 mm. Drill hole available for control cable. NZM3-XKA1 1 off 271459 NZM3-4-XKA1 1 off 271460 NZM3-XKA2 1 off 271461 NZM3-4-XKA2 1 off 271462 Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuitbreakers. A standard with control circuit terminal for 1 x 0.75 – 2.5 mm² (18 – 14 AWG) or 2 x 0.75 – 1.5 mm² (18 – 16 AWG) copper conductors.Fitted outside the switch housing. Use with flexible and highly flexible conductors ferrules. Maximum specified cross-section can only be connected when stranded and without ferrules. Mounting of the cover NZM3(-4)-XKSA obligatory (supplied). Please note a maximum diameter of 20.5 mm resp. 22.5 mm. 20 Connection types Ordering LZM3 EATON CORPORATION CA012002EN Cover – LZM3(-4) 3 pole NZM3-XKSA LN3(-4) 260045 – 4 pole NZM3-4-XKSA 266801 Max. cable connection For use with Part no. Price area Article no. when see price ordered separately list Phase isolator – LZM3(-4) 3 pole NZM3-XKP LN3(-4) 100512 – 4 pole NZM3-4-XKP 100513 Copper cable lug When using cable lugs without NZM3(-4)-XKSA cover, they must be insulated. 185 mm² LZM3(-4), LN3(-4) 3 and 4 pole NZM3-XKS185 LZM4(-4), LN4(-4) 260040 240 mm² NZM3-XKS240 260041 300 mm² NZM3-XKS300 153186 Connection types 21 Ordering LZM3 EATON CORPORATION CA012002EN 1 off 1 off Std. pack Notes Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Insulation/protection against direct contact where cable lugs, busbars or tunnel terminals are used. Included in set with tunnel terminals. Degree of protection IP1X on the connection side when using insulated conductor material. 1 off 1 off Type contains parts for a terminal located at top or bottom for 3 or 4 pole circuit-breakers. Included with the connection width extension. Cannot be combined with the NZM3(-4)-XKA tunnel terminal, NZM3(-4)-XKR connection on rear. Insulation protection with connection of cable lugs, busbars or braid. 1 off Type contains a cable lug for 3-pole or 4-pole switches. Special cable lug, narrow style 22 Connection types Ordering LZM4 EATON CORPORATION CA012002EN Screw connection Standard equipment 2-hole max. 1600 LZM4(-4) Three- and Cu cable 1 x 120 – 185 1 x 250 – 350 with LN4(-4) four-pole lugs 4 x 50 – 185 4 x 0 – 350 stud bolts and nuts. Max. cable
