PPC380AE02 HIEE300885R0102工控模块备件
对连接到控制单元的每个垫重复此过程,检查相应的通道故障LED是否变为红色。仅手动重置模式1。检查控制单元:绿色LED-电源亮起绿色LED-机器启用亮起通道故障LED 1至8亮起绿色,与安装的垫数量相匹配。2.站在1号垫子上,检查机器启用LED熄灭,信道故障LED变为红色。3.离开垫子,通过操作重置按钮手动重置系统,然后检查控制系统是否恢复到与上述第1项相同的状态。4.对连接到控制单元的每个垫重复该过程,检查相应的通道故障LED变为红色。注意通道故障状态LED指示单个垫的操作或故障。34控制单元-操作模式(440F-C28013)自动复位通电:电源、自动复位和机器启用LED亮起。当垫子工作时:机器启用的LED熄灭备用垫子:机器启用LED点亮手动重置通电:电源、手动重置和机器启用LED亮起。按下重置按钮:机器启用的LED在垫子运行时亮起:机器启用LED熄灭垫:机器启用发光二极管仍熄灭按下重置按钮,机器启用LED亮起在故障情况下,机器启用的灯熄灭,在故障排除之前不允许重置。在故障状态下,如果存在垫子故障,一个或多个垫子状态LED将点亮。. Repeat process for each mat connected to the control unit checking the corresponding CHANNEL FAULT LED changes to RED. Manual reset mode only 1. Check on the control unit that: The green LED - POWER is illuminated The green LED - MACHINE ENABLED is illuminated The CHANNEL FAULT LED’s 1 to 8 are illuminated green matching the number of mats installed. 2. Stand on mat number 1 and check the MACHINE ENABLED LED goes off and the CHANNEL FAULT LED changes to RED. 3. Step off the mat, manually reset the system by operating the RESET BUTTON and then check that the control system returns to the same state as item 1 above. 4. Repeat process for each mat connected to the control unit checking the corresponding CHANNEL FAULT LED changes to RED. Note that CHANNEL FAULT STATUS LED’s indicate individual mat operation or fault. 34 Control unit - Mode of operation (440F-C28013) Auto reset On power up: Power, auto reset and machine enabled LED’s illuminate. When mat operated: Machine enabled LED goes out Stand off mat: Machine enabled LED illuminates Manual reset On power up: Power, manual reset and machine enabled LED’s illuminate. Press reset button: Machine enabled LED illuminates When mat operated: Machine enabled LED goes out Stand off mat: Machine enabled LED still out Press reset button: Machine enabled LED illuminates Under fault condition Machine enabled light goes out and will not allow reset until fault is rectified. In the fault condition if there is a mat fault, one or more of the MAT STATUS LED’s will be illuminated.