CP450C 工控模块系统备件
为了便于连接，发射器的尾光纤连接器有一个白色标记，接收器有一个蓝色标记。确保用白色标记将发射器连接到控制器上的插头，用蓝色标记将接收器连接到插头。阵列LED描述颜色含义绿色（控制器上也有LED D1）光阵列对准偏离目标存在或阵列未对准绿色目标不存在，阵列对齐且在范围内绿色（闪烁）光强度不足红色（控制器上还有LED D2）光阵列状态关闭目标不存在（和阵列对齐）红色目标存在（或阵列未对齐）红色（闪烁）高度测量错误此外，提供的连接器电缆两端都连接有蓝色和白色环。拆下发射器电缆上的蓝色标记和接收器电缆上的白色标记，以便对电缆进行适当标记，以备将来使用。各个灯阵列通过该连接到控制器供电。请参阅与您使用的特定控制器对应的安装说明，以了解有关控制器接线和连接的更多详细信息。校准这是设置中的关键步骤，因为传感器操作取决于发射器和接收器的正确校准。通过使用接收器单元上的绿色LED作为正确对准的指示，简化了该过程。水平对齐1.将接收器对准发射器（光源）90°，并验证接收器和发射器上的红色状态LED是否均已打开。2.缓慢旋转接收器，使其面向发射器，并注意这些红色LED熄灭且绿色对齐LED亮起的点。3.继续旋转接收器，远离发射器，直到绿色LED再次熄灭，红色LED亮起。注意发生这种情况的时间点。
For ease of connection, the pigtail connector for the emitter has a white marker, and the receiver has a blue marker. Be sure to connect the emitter to the plug connection on the controller with the white marker, and the receiver to the plug connection with a blue marker. Array LED Description Color Meaning Green (also LED D1 on controller) Light array alignment Off Target present or arrays not aligned Green Target not present, arrays aligned and within range Green (flashing) Light intensity inadequate Red (also LED D2 on controller) Light array status Off Target not present (and arrays aligned) Red Target present (or arrays not aligned) Red (flashing) Height measurement error In addition, the connectors cables are offered with both blue and white rings attached to each end of each cable. Remove the blue markers from the emitter's cable and the white ones from the receiver's cable so that the cables are marked appropriately for future use. The individual light arrays are powered through this connection to the controller. Please refer to the Installation Instructions corresponding to the specific controller that you are using for further details on wiring and connecting the controller. Alignment This is a crucial step in the setup since sensor operation is dependent on correct alignment of the emitter and receiver. This process is simplified by using the green LED on the receiver unit to serve as an indication of proper alignment. Horizontal Alignment 1. Aim the receiver 90° away from the emitter (light source) and verify that the red status LEDs on both the receiver and emitter are ON. 2. Slowly rotate the receiver to face the emitter and note the point at which these red LEDs turn OFF and the green alignment LED turns ON. 3. Continue to rotate the receiver away from the emitter until the green LED turns OFF again, and the red LEDs turn ON. Note the point at which this happens.
