TRICONEX 9572-610工控备件机器人模块
根据使用情况
建议每个月更换一次但不得超过个月。电机类别。轴密封套件目录。不和和和和和和和和自动化出版物月这是一个很好的例子旋转运动规格技术规格系列低惯量电机系列低惯量电动机级性能规格电机类别。速度最大连续失速扭矩••峰值失速扭矩··电机额定输出电机额定输出转速转子惯性时的转速••关于制动转子惯性和制动电机重量请参阅第页的系列低惯性电机制动器规格。电机重量约千克磅版本自动化出版物年月旋转运动规格系列低惯量电机级性能规格电机类别。速度最大连续失速扭矩••峰值失速扭矩··电机额定输出电机额定输出转速转子惯性时的转速••关于制动转子惯性和制动电机重量请参阅第页的系列低惯性电机制动器规格。电机重量约千克磅版本。
英里自动化出版物年月旋转运动规格系列低惯量电机制动器规格电机类别。数量最大制动器接合弧分钟齿隙保持扭矩••制动响应时间时的线圈电流制动转子惯性••制动电机重量约释放接合通过使用外部消弧装置二极管下表中列出的荷载。所列径向载荷施加在轴外伸部的中间。下表表示轴承疲劳寿命为小时。这小时的使用寿命没有考虑到因外部来源的轴承润滑脂污染而可能导致的特定应用寿命减少。最大运行速度受电机绕组限制。
According to the usage
It is recommended to replace it once a month but not more than months. Motor category. Catalog of shaft seal kits. Discord and Harmony and Harmony and Automation Publications Month This is a good example of the rotating motion specification specification series Low inertia motor series Low inertia motor level performance specification motor category. Speed Maximum continuous stall torque • • Peak stall torque • • Motor rated output motor rated output speed Speed at rotor inertia • • For brake rotor inertia and brake motor weight, refer to the series low inertia motor brake specifications on page. Motor weight is about kg pounds version Automation publication Year Month Rotating motion specification series Low inertia motor level performance specifications Motor category. Speed Maximum continuous stall torque • • Peak stall torque • • Motor rated output motor rated output speed Speed at rotor inertia • • For brake rotor inertia and brake motor weight, refer to the series low inertia motor brake specifications on page. The motor weighs about kg pounds.
Mile Automation Publications Year Month Rotating Motion Specifications Series Low Inertia Motor Brake Specifications Motor Category. Number of Maximum Brake Engaged Arcs Minute Backlash Retention Torque • • Coil Current at Brake Response Time Brake Rotor Inertia • • Brake Motor Weight Approximately Released Engaged By Using External Arc Suppression Device Diodes The loads listed in the table below. The listed radial loads are applied in the middle of the shaft extension. The following table shows that the bearing fatigue life is hours. The service life at this hour does not take into account the specific service life reduction that may result from contamination of bearing grease from external sources. The maximum operating speed is limited by the motor winding.
