TRICONEX 9667-910自动化工控模块
直径功率
输入直径。直径的通孔需要。直径上的直径为安装螺栓必须为型带帽螺钉，轴详螺纹孔最小深度检查孔，顶部和底部堵头凹进飞边和轴封提供全深度端铣键槽换向解析器或高分辨率输出电机前端钟形角半径吊钩详高分辨率电机端轴和导向公差最大轴跳动轴端隙最大导向偏心度最大端面跳动铭牌法兰安装详单位：毫米和英寸反馈目录编号描述键端铣键槽全深度旋转器，无制动器，,无制动器，,×，,高分辨率无制动器无制动器至。
如果订购带有可选制动器额定值的，则和增加增加。尺寸符合标准和。轴公差符合，公差。，系列，交流伺服电机出版物年月电机输出轴径向负载与。推力载荷径向载荷推力径向载荷磅推力磅径向载荷推力轴向力径向力交流伺服电机小时轴承寿命垂直或水平安装，系列，交流伺服电机出版物年月伺服电机选项本节提供了有关可用各种选项的详细信息，扭矩加伺服电机。整体保持制动器选件当断电时，盘式制动器为弹簧设置。其设计用于保持负载静止，并为紧急停止提供有限的制动扭矩。制动器不打算用作定位制动器制动器间隙最大为弧分，也不打算连续循环以帮助停止负载。
Diameter power
Enter the diameter. Diameter through hole is required. The diameter on the diameter is that the mounting bolt must be a type cap screw. See the minimum depth inspection hole of the threaded hole for the shaft, Top and bottom plug recessed flash and shaft seal provide full depth end milling keyway reversing resolver or high-resolution output motor front end bell angle radius hook See high-resolution motor end shaft and guide tolerance Maximum shaft runout Maximum shaft end clearance Maximum guide eccentricity Maximum end runout Nameplate flange installation Details Unit: mm and inch Feedback catalog number Description Key end milling keyway full depth rotator, without brake, without brake,, ×，, High resolution no brake no brake to.
If ordering with optional brake ratings, add and. The dimensions comply with the standards and. Shaft tolerance complies with, tolerance., Series, AC Servo Motor Publications Month Motor Output Shaft Radial Load vs. Thrust load Radial load Thrust radial load Thrust pound Radial load Thrust axial force Radial force AC servo motor Hourly bearing life Vertical or water safe installation, series, AC servo motor publication Monthly servo motor options This section provides detailed information about the various options available, torque plus servo motor. Integral holding brake option When power is off, the disc brake is spring set. It is designed to hold the load stationary and provide limited braking torque for emergency stop. The brake is not intended to be used as a positioning brake. The brake clearance is maximum minutes of arc, and it is not intended to circulate continuously to help stop the load.
