TRICONEX 9668-110工业备件
电源输入
换向分解器或高分辨率输出检查孔，顶部和底部至插头，直径。直径的通孔需要。直径为，在直径为的上安装螺栓必须为帽头式螺纹孔，最小深度轴详全深度端铣键槽电机前端钟形角半径最大轴跳动轴端隙最大导向偏心最大端面跳动铭牌详轴和导向公差高分辨率电机端部法兰安装单位：毫米和英寸反馈目录编号描述键端铣键槽全深度无制动器无制动器，无制动器，不带制动器的，可选，制动器等级，和增加。尺寸符合标准和。轴公差符合，扭矩增强系列，交流伺服电机出版物年月扭矩增强系列分解器和高分辨率反馈键最大值直径。直径直径。直径。直径直径。
直径功率输入轴详直径
直径上需要通孔。直径上的直径安装螺栓必须为帽头式检查孔，顶部和底部至堵头螺纹孔深最小全深端铣键槽凹形飞边和轴封提供换向分解器或高分辨率输出吊钩详电机前端钟形角半径铭牌详轴和导向公差高分辨率电机端最大轴跳动轴端隙最大导向偏心最大端面跳动法兰安装单位：毫米和英寸反馈目录编号描述键端铣键槽全深度旋转器，则和增加增加。尺寸符合标准和。轴公差
交流伺服电机出版物年月扭矩增强系列分解器和高分辨率反馈键最大值直径。
Power input
Reversing resolver or high-resolution output inspection hole, top and bottom to plug, diameter. Diameter through hole is required. The installation bolt on the motor with a diameter of must be a cap type threaded hole. See full depth end milling keyway for the minimum depth shaft. The front end bell angle radius of the motor has the maximum shaft runout. The maximum shaft runout. The maximum guide eccentricity. The maximum end face runout nameplate has the shaft and guide tolerance. The installation unit of the high resolution motor end flange is mm and inch. The feedback catalog number describes that the key end milling keyway has the full depth, no brake, no brake, and no brake, Optional, brake class, and increase. The dimensions comply with the standards and. The shaft tolerance conforms to the maximum diameter of torque enhancement series, AC servo motor publication torque enhancement series resolver and high-resolution feedback key. Diameter diameter. Diameter. Diameter diameter.
Diameter See diameter for power input shaft
A through hole is required on the diameter. The diameter mounting bolts on the diameter must be hat type inspection holes, The minimum full depth end milling keyway concave flash and shaft seal from the top and bottom to the plug threaded hole depth provide reversing resolver or high-resolution output hook. See the motor front end bell angle radius nameplate. See the shaft and guide tolerance. High resolution motor end maximum shaft runout. Shaft end clearance. Maximum guide eccentricity. Maximum end face runout. Flange installation unit: mm and inch. Feedback catalog number. Description. Key end milling keyway full depth rotator. Then, and increase. The dimensions comply with the standards and. Shaft tolerance
AC Servo Motor Publications Month Torque Enhancement Series Resolver and High Resolution Feedback Keys Maximum Diameter.
