TRICONEX 9783-110模块控制器
向上滑动主控制板
然后将其拔下。卸下连接到主控制板的所有通信板和支架如所示。将主控制板放在防静电袋中。备件#系列装置系列装置目录号系列类型$&，'&&$$$数据铭牌位于主控制板目录号系列标识符附近装置上的新主控制板例如，如果的数据铭牌具有系列标识符或电流监测，新的主控制板应标有目录号！注意：如果存在任何电压，请移除电压源。继续下一步前，再次检查电压。出版物年月™主控制板更换固件版本主控制板拆卸安装通信板至笔记本电脑仅用于升级固件至扫描端口设备至扫描端口装置至桥接器热传感器可用于用户连接至隔离板至至栅极驱动板模拟安装螺钉支座连接端口连接盖出版物年月™主控制板更换固件版本安装主控制板。戴上腕带并将其连接到母线。
安装之前从主控制板上拆下的所有通信板如所示
将所有安装螺钉拧紧至。将主控制板向下滑动到滑动支座支座上。将主控制板安装到安装板上。将安装螺钉拧紧至。将连接到主控制板。确认所有端子都牢固。如所示，连接和。结束步骤安装主控制板后，从装置中移除所有工具和碎屑，并固定隔间门。根据贵公司的程序和当地条例，将旧电路板送至自动化公司进行维修或处理！注意：操作装置前必须配置参数。请参阅出版物的启动章节，以配置新主控制板中的参数。
Slide the main control board up
Then pull it off. Remove all communication boards and brackets connected to the main control board as shown in. Place the main control board in the anti-static bag. Spare Part # Series Device Serial Device Catalog Number Series Type $&, '&&$$$$Data plate is located on the new main control panel on the device near the catalog number series identifier of the main control panel For example, if the data plate has a series identifier or current monitoring, the new main control panel should be marked with a catalog number! Note: If any voltage is present, remove the voltage source. Check the voltage again before proceeding to the next step. Publication date ™ Main Control Board Replacement Firmware Version Main Control Board Removal and Installation of Communication Board to Laptop Only for Upgrading Firmware to Scan Port Device to Scan Port Device to Bridge Thermal Sensor Available for Users to Connect to Isolation Board to Grid Drive Board Analog Installation Screw Support Connection Port Connection Cover Publication Year Month ™ Replace the firmware version of the main control board and install the main control board. Wear a wrist strap and connect it to the bus.
All communication boards removed from the main control board before installation are shown in
Tighten all mounting screws to a torque of. Slide the main control board down onto the sliding support. Install the main control board onto the mounting plate. Tighten the mounting screws to a torque of. Connect to the main control board. Verify that all terminals are secure. Connect and as shown in. At the end of the procedure, after installing the main control panel, remove all tools and debris from the unit and secure the compartment door. Send the old circuit board to the automation company for repair or disposal according to your company's procedures and local regulations! Note: The parameters must be configured before operating the device. Refer to the launch section of the publication to configure the parameters in the new main control panel.
