TRICONEX 9785-610工控模块
套件说明™主控制板更换固件版本内容本文档介绍了如何卸下和更换再生直流母线电源单元中的主控制板。此套件包含的内容使用下表，验证您是已收到套件中的适当项目：其他需要的项目在开始之前，请确保您还具备以下各项：您需要的工具：–测量电压–拆卸松开，和紧固螺钉包括端子螺钉–扭转螺钉至至文档：–您的驱动系统示意–出版物，再生直流母线供电单元–用户手册本部分：您应该收到此数量：主控板腕带出版物年月™主控制板更换固件版安全注意事项在维修或驱动系统配置时，
特别说明重要提示：
您需要重新使用从设备上拆下的零件。按照拆下的顺序将零件放在干净的表面上。重要提示：新的主控制板可能不包括与现有板相同的参数设置。如有必要，请在更换主控制板之前记录参数设置！注意：只有熟悉驱动系统系统中使用的产品和相关机械的人员才能计划或实施系统的安装启动和未来维护。不遵守可能导致人身伤害和或设备损坏。注意：根据第二部分的要求，验证所有交流和直流电源是断电上锁或挂牌。
Kit Description ™ Main control board replacement firmware version content This document describes how to remove and replace the main control board in the regenerative DC bus power supply unit. Contents of this kit Use the following table to verify that you have received the appropriate items in the kit: Other required items Before starting, please ensure that you also have the following items: Tools you need: – Measuring voltage – Removing and loosening, and fastening screws including terminal screws – Twisting screws to documents: – Your drive system schematic – Publications, Regenerative DC bus power supply unit – user manual This part: You should receive this quantity: master control board wrist strap publication Month Year ™ Safety precautions for replacing firmware version of main control board,
Special notes Important notes:
You need to reuse the parts removed from the equipment. Place the parts on a clean surface in the order they were removed. Important: The new main control board may not include the same parameter settings as the existing board. If necessary, record the parameter settings before replacing the main control board! Note: Only personnel familiar with the products and related machinery used in the drive system can plan or implement the installation, startup and future maintenance of the system. Failure to comply may result in personal injury and or equipment damage. Note: According to the requirements of Part II, verify that all AC and DC power supplies are locked out or tagged out.
