TRICONEX 9789-610 PLC备件
没有电源顺序限制
将逻辑电平跳线移动到所需位置，以设置引脚状态或外部驱动，如逻辑电平跳线部分所述。如何使用操作：默认情况下，跳线用于控制，如所示。通过直接插入将连接到板，就像安装了屏蔽一样。将逻辑电平跳线设置为位置。将和跳线设置到所需位置和均为有效选项如果使用外部电源，请将其连接到炮塔；则将提供董事会。电源跳线请参阅上面的步骤必须设置为与此配置相匹配。使用电缆将插入运行应用程序的计算机。
在计算机上
打开为该板编写的草可在解决方案，并上传到。打开串行监视器。将通信速率设置为波特，然后选择&。此时会显示一个菜单，提供运行演示电路和的程序的选项，如所示。可以通过键入并按键来单独控制逻辑引脚。选择和向施加信号。选项至控制多个引脚，将配置为指定的操作模式。所有逻辑输入都可以在电路板左侧的测试点进行监控。演示手册零件清单项目数量参考零件描述制造商零件号所需电路组件，单总线收发器，由线性技术公司提供的信息被认为是准确可靠的。但是，对其使用不承担任何责任。不表示其电路的互连不会侵犯现有专利权。
No power sequence restriction
Move the logic level jumper to the desired position to set the pin status or external drive, as described in the logic level jumper section. How to use the operation: By default, the jumper is used for control, as shown in. Connect to the board by inserting it directly, as if the shield was installed. Set the logic level jumper to position. Set the and jumpers to the required position and are both valid options. If an external power supply is used, please connect it to the turret; The board of directors will be provided. Refer to the steps above for the power cord. It must be set to match this configuration. Use the cable to plug into the computer where the application is running.
On the computer
Open the draft prepared for this board and upload it to the solution. Turn on the serial monitor. Set the communication rate to baud and select&. A menu will be displayed, providing the option to run the demo circuit and program, as shown in. The logic pins can be individually controlled by typing and pressing. Select and apply signals to. Options to control multiple pins will be configured to the specified operation mode. All logic inputs can be monitored at the test point on the left side of the circuit board. The number of items in the parts list of the demonstration manual refers to the description of the parts. The manufacturer's part number requires circuit components, single bus transceivers. The information provided by Linear Technology is considered accurate and reliable. However, we do not assume any responsibility for its use. It does not mean that the interconnection of its circuits will not infringe the existing patent rights.
