VMIVME-4140-010000备件模块
输入电压接触器
交流线圈直流线圈 交流线圈 直流线圈 。最大损耗驱动类别。不最大损耗 耗散分流器 耗散分流 耗散分流 耗散分流 耗散分流器 耗散分流 耗散分流 耗散分流属性值可选通信速率和 节点地址… 可选网络功耗 数据速率和 以及自动波特率节点地址…消息功能显式轮询状态更改和循环消息串行端口一个通信速率和 自动化出版物年月 数字伺服驱动器第章输入输出规范辅助反馈规范物理和环境规范连接器规范属性值数字输入光学隔离…有源高电流陷波数字输出光学隔离有源高电流源继电器输出一个常开继电器 最大 最大响应μ数字固件扫描周期 模拟输入 位 位至模拟输出位 最大属性值输入模式 步进方向最大输入频率 输入类型差分单端建议使用开路集电极差动输入类型。属性值属性值重量约为 重量约 磅 温度环境工作温度…………相对湿度…%非冷凝海拔米英尺米英尺以上每米英尺降低%振动
连接器电机反馈连接器
峰值英寸最大位移冲击 半正弦连接器说明规范用户输入输出针高密度凹形形子连接器电机反馈连接器针高密度凸形形副连接器串行端口连接器针凹形型子连接器和主和辅助交流直流总线电机电源和分流连接器螺纹接线板自动化出版物年月 数字伺服驱动器第章在下图中被替换分别代表 和 驱动器。 尺寸驱动器表示索引选项。表示接口接口选项。接口不适用于接口选项。 驱动器构成了一系列灵活高性能的数字伺服驱动器适用于各种运动控制应用和架构。
Input voltage contactor
AC coil DC coil AC coil DC coil. Maximum loss drive category. Not Maximum Loss Dissipative Diverter Dissipative Diverting Dissipative Diverting Dissipative Diverting Dissipative Diverting Dissipative Diverting Dissipative Diverting Attribute Values Optional Communication Rate and Node Address... Optional Network Power Consumption Data Rate and Automatic Baud Rate Node Address... Message Function Explicit Polling State Change and Cyclic Message Serial Port One Communication Rate and Automation Publication Month Digital Servo Driver Chapter I/O Specifications Auxiliary feedback specifications Physical and environmental specifications Connector specifications Attribute values Digital input Optical isolation... Active high current notch digital output Optical isolation Active high current source relay output Maximum maximum response of a normally open relay μ Digital firmware scanning cycle Analog input bit to analog output bit Maximum attribute value Input mode Step direction Maximum input frequency Input type Differential single end Open collector differential input type is recommended. Attribute Value Attribute Value Weight Approx. Pounds Temperature Ambient Operating Temperature............ Relative Humidity.........% Non Condensing Altitude m ft m ft Above% Vibration Reduction per m ft
Connector Motor Feedback Connector
Peak inch maximum displacement impact half sine connector specification User input and output pin High density concave sub connector Motor feedback connector pin High density convex sub connector Serial port connector Pin concave sub connector and main and auxiliary AC/DC bus Motor power supply and shunt connector Threaded terminal block Automation publication Month Year Digital servo driver Chapter is replaced in the following figure to represent and drive respectively. Size drives represent indexing options. Represents interface options. Interface is not available for interface options. The drivers constitute a series of flexible and high-performance digital servo drivers suitable for various motion control applications and architectures.
