VMIVME-7750-466000工控机器人备件
背光控制部件
尽可能靠近 触摸屏接口模块集成了由控制的线触摸屏是 总线上的从属设备控制器发回关于和位置的信息以及施加到触摸面板的压力的测量值触摸面板可以与手写笔或手指一起使用触摸面板控制器通过控制信号连接到接口连接两个中断信号并将事件信息提供给微控制器：和注意：与信号共享与信号共享因此如果与触摸屏控制器同时使用接口请注意不要在或上同时启用两个驱动程序为此这些线路上安装了欧姆电阻器以断开任何一端驱动器与另一端驱动器的连接：在触摸面板控制器侧
连接到测试点
的触摸辅助输入/连接到测试点用于可选功能扩展图触摸面板控制 /标准针/连接器在上实现用于连接兼容的 仿真器接口例如的注：信号连接到系统按钮也用于重置模块可以移除欧姆电阻器以便将端口与该系统复位信号隔离当 未处于调试模式时引脚处于输入模式上拉电阻器禁用为了避免由于浮动输入导致 评估套件硬件开发板用户指南 ––年月日图接口音频接口板支持音频录制和回放可使用电位计调节音频音量并可通过跳线调节麦克风放大器增益（固定增益为或 ）
Backlight control unit
As close as possible to the touch screen interface module, the controlled line is integrated. The touch screen is the information about and the position sent back by the slave device controller on the bus and the measured value of the pressure applied to the touch panel. The touch panel can be used together with the stylus or finger. The touch panel controller connects two interrupt signals through the control signal connection to the interface and provides the event information to the microcontroller: and Note: signal sharing and signal sharing Therefore, if the interface is used with the touch screen controller at the same time, please be careful not to enable two drivers on or at the same time. Ohmic resistors are installed on these lines to disconnect the driver at either end from the driver at the other end: on the controller side of the touch panel
Connect to test point
Touch auxiliary input of/connected to the test point for optional function extension diagram Touch panel control/standard pin/connector is implemented on for connecting compatible emulator interfaces Note: the signal is connected to the system button is also used to reset the module Ohm resistor can be removed to isolate the terminal from the system reset signal When the pin is in input mode when not in debug mode Pull up resistor is disabled to avoid floating input Evaluation Kit Hardware Development Board User's Guide – – Year Month Day Chart Interface Audio interface board supports audio recording and playback You can use a potentiometer to adjust the audio volume and adjust the microphone amplifier gain through a jumper (fixed gain is or)
